User manual CLARION VM700B

[. . . ] Do not operate your monitor in ways other than those described in this manual. â· Do not play a multimedia system when the vehicle's engine is turned off. If the temperature in the vehicle is high or the monitor has been exposed to direct sunlight, cool the monitor (such as, by running the air conditioning) before you turn it on. â· Keep all liquids, including beverages and cleaning fluids away from the monitor. [. . . ] Note : If two monitors are used for the rear entertainment systems, and single channel wireless headphones are used; either one of the monitor's IR channel must be turned "OFF". The monitor is preset at the factory to turn on automatically when the vehicle's ignition is turned on. Insert the media (tape, cartridge, game or disc) into the video source. If this is the first time you've used the unit, make sure your wireless headphones have fresh batteries installed. Note : Your wireless headphones must be in view of the monitor for the infrared transmission to work. English Owner's Manual To choose the proper display mode for the different video sources, please refer to display mode setting below. WIDE may stretch the image to fill the entire screen, NORMAL displays the image at its true aspect ratio (4:), WIDE stretches the image horizontally to fit the screen for aspect ratio of 16:9. When using a DVD player as the source, make sure that the unit's output mode is set to "WIDE" or "16:9". This ensures that the DVD player will generate a video signal, which can take advantage of the monitor's aspect ratio. â· When using a source that generates a "normal", 4:3 image signal, such as a video game or video cassette player, the WIDE mode stretches the image to fit the screen. â· Video format are automatically select between PAL or NTSC depending on the video format. For optimum picture quality, the tint, color, brightness, and contrast can be adjusted independently. Press the MENU key again until you reach the option you wish to adjust. Once you've adjusted the picture, wait a moment and the adjustment menus disappear. When you turn the vehicle's ignition off, the monitor automatically shuts off. English If your vehicle has two video sources, for example, a DVD player goes to Video1 and a game console goes to Video, you can easily switch between them. Press the SOURCE key to select the input for Video for the game console. If you're using only one video source, the screen remains dark when you select the unavailable source. If your vehicle is equipped with two LCD monitors in the headrests and two video source units, two different video sources can be viewed at the same time. Each monitor transmits the infrared audio signal over its own channel, A or B. When a vehicle has two monitors, the default is to configure the monitor in the driver's headrest to use IR channel A, and the monitor in the passenger's headrest to use IR channel B. Press down " " or up " " to alternate between A and B or OFF. [. . . ] Cut the opening and the foam in the headrest along the marked line with utility knife. Route the power cable from the back side of the monitor through the side opening of the mounting tray. Press the edges of the monitor, not on screen, until it snaps in the tray. If you find that you cannot insert the monitor without excessive force, you may need to check your wire harness position for interference with the insertion process. [. . . ]