User manual CLARION S660

[. . . ] Model S660 O Owner's Guide limited lifetime consumer warranty This Ungo Pro Security system is warranted against defects in material and workmanship. This Limited Lifetime Warranty applies to Ungo Pro Security systems that have been installed by an authorized Ungo Pro Security dealer. This warranty is to the Original Purchaser ("Owner") and to the original vehicle in which it was installed into. This warranty is not transferable to any subsequent owner(s) of the product(s). [. . . ] If the system is triggered and the siren has been sounding for longer than six seconds, pressing on the remote will stop the trigger and return the unit to the armed state. This prevents you from disabling the system should you wish to disarm it without visually checking the vehicle. Pressing after resetting the system will disarm the system; pressing this button during the first six seconds of the triggered sequence will disarm the security system immediately. The six second timer is provided for your convenience, in case the system is accidentally triggered. © 2005 directed electronics, inc. 25 disarming without a remote If your remote is lost or damaged, you can manually disarm your vehicle security system. To disarm the system without a remote, you must have the vehicle's ignition key and know where the Valet® button is located. Be sure to check with your installer at the time of installation for both the location and the preset response (1-5 presses) of the Valet® button. Press the Valet® button the preset number of times (one to DRW-35 five times) within 15 seconds. If the system does not disarm, you may have waited too long; turn the ignition off and on and try again. Location of Valet® Button_________________________________ Number of Presses_____________________________________ important!The Valet® button can be programmed to respond to 1-5 presses for the disarm function. You must check with the installer to verify the programming for your individual unit. 26 © 2005 directed electronics, inc. silent mode To temporarily turn off the arm or disarm chirps, use Silent ModeTM. Simply press for less than one second before arming or disarming, and the confirmation chirp(s) will be eliminated for that one operation only. If you want the arm/disarm chirps turned off permanently, your dealer can do this for you. note: The Warn Away® response to lighter impacts is bypassed if the system is armed using Silent Mode. This ensures that no chirps will be emitted by the siren in an area you want chirp-free. Only the Warn Away® response is bypassed. panic mode If you are threatened in or near your vehicle, you can attract attention by triggering the system with your remote. The siren will sound and the parking lights will flash for the programmed siren duration. To stop Panic Mode at any time, press the remote again. note: Once panic mode has been entered, the siren will sound for the programmed duration. on The LCD 2-way remote will beep (or vibrate) continuously when the system enters panic mode. The 2-way remote will not generate a page notification when panic mode is exited. © 2005 directed electronics, inc. 27 valet® mode You can prevent your security system from automatically arming and triggering by using Valet® Mode. In Valet® Mode, the security system will not arm, even with the remote, but all convenience functions (door locks, trunk release, etc. ) will continue to work normally. To enter or exit Valet® Mode: 1. The status LED will light solidly if you are entering Valet® Mode, and it will go out if you are exiting Valet® Mode. To enter or exit Valet® Mode using the remote: DRW-35 Steps 2 through 3 must be quickly and smoothly completed. Press The status LED will light solidly if you are entering Valet® Mode, and it will go out if you are exiting Valet® Mode. 28 © 2005 directed electronics, inc. setting the clock To set the clock press and hold Immediately press for five seconds, the transceiver will chirp twice and the hour selection will start flashing. Once the correct hour is displayed press again and the minute selection will start flashing. Then press to advance the minute selection to reverse the minute selection. [. . . ] The chirps can be either full volume or 6 decibels quieter than the full alarm blast. security & convenience expansions Listed below are some of the many expansion options available. Please consult your dealer for a complete explanation of all the options available to you. Audio Sensor: Metal on glass, glass cracking, and breaking glass produce distinctive acoustic signatures. The 506T audio sensor uses a microphone to pick up sounds, then analyzes them with proprietary acoustic software to determine if the glass has been struck. Backup Battery: The 520T keeps the system armed, triggers the alarm and keeps the starter interrupt active if main battery is disconnected. © 2005 directed electronics, inc. 39 Hood Lock: Prevents the vehicle's hood from being opened without a key, keeping thieves away from the system's siren, the battery connections, and other components under the hood. Field Disturbance Sensor: An invisible dome of coverage is estab- lished by installing the 508D "radar" sensor. Your system can react to any intrusions into this field with the full triggered sequence. Power Locks: This system offers lock outputs that can control some manufacturers' power door lock systems. [. . . ]