User manual CLARION RS10

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CLARION RS10. We hope that this CLARION RS10 user guide will be useful to you.


CLARION RS10 : Download the complete user guide (784 Ko)

You may also download the following manuals related to this product:

   CLARION RS10 INSTALLATION GUIDE (1225 ko)

Manual abstract: user guide CLARION RS10

Detailed instructions for use are in the User's Guide.

[. . . ] Clarion will not assume any responsibility for any loss or damage incurred in shipping. ALL IMPLIED WARRANTIES EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW SHALL HAVE NO GREATER DURATION THAN THE WARRANTY PERIOD SET FORTH ABOVE. UNDER NO CIRCUMSTANCES SHALL CLARION CORPORATION BE LIABLE FOR ANY LOSS OR DAMAGE, DIRECT OR CONSEQUENTIAL, ARISING OUT OF THE USE OR INABILITY TO USE OF THE PRODUCT. BECAUSE SOME STATES DO NOT ALLOW LIMITA- © 2006 Directed Electronics--all rights reserved i TIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR EXCLUSIONS OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. [. . . ] When properly installed, this system can start the vehicle via a command signal from the remote control transmitter. Therefore, never operate the system in an enclosed area or partially enclosed area without ventilation (such as a garage). When parking in an enclosed or partially enclosed area or when having the vehicle serviced, the remote engine © 2006 Directed Electronics--all rights reserved 5 start system must be disabled using the installed toggle switch. It is the user's sole responsibility to properly handle and keep out of reach from children all remote control transmitters to assure that the system does not unintentionally remote engine start the vehicle. THE USER MUST INSTALL A CARBON MONOXIDE DETECTOR IN OR ABOUT THE LIVING AREA ADJACENT TO THE VEHICLE. ALL DOORS LEADING FROM ADJACENT LIVING AREAS TO THE ENCLOSED OR PARTIALLY ENCLOSED VEHICLE STORAGE AREA MUST AT ALL TIMES REMAIN CLOSED. Use of this product in a manner contrary to its intended mode of operation may result in property damage, personal injury, or death. (1) Never remotely start the vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the keys in the ignition. The user must also have the neutral safety feature of the vehicle periodically checked, wherein the vehicle must not remotely start while the car is in gear. This testing should be performed by an authorized Ungo dealer in accordance with the Safety Check outlined in the product installation guide. If the vehicle starts in gear, cease remote engine start operation immediately and consult with the authorized Ungo dealer to fix the problem. After the remote engine start module has been installed, contact your authorized dealer to have him or her test the remote engine start module by performing the Safety Check outlined in the product installation guide. If the vehicle starts when 6 © 2006 Directed Electronics--all rights reserved performing the Neutral Safety Shutdown Circuit test, the remote engine start unit has not been properly installed. The remote engine start module must be removed or the installer must properly reinstall the remote engine start system so that the vehicle does not start in gear. OPERATION OF THE remote engine start MODULE IF THE VEHICLE STARTS IN GEAR IS CONTRARY TO ITS INTENDED MODE OF OPERATION. OPERATING THE remote engine start SYSTEM UNDER THESE CONDITIONS MAY RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY. YOU MUST IMMEDIATELY CEASE THE USE OF THE UNIT AND SEEK THE ASSISTANCE OF AN AUTHORIZED UNGO DEALER TO REPAIR OR DISCONNECT THE INSTALLED remote engine start MODULE. UNGO WILL NOT BE HELD RESPONSIBLE OR PAY FOR INSTALLATION OR REINSTALLATION COSTS. Locking Pressing for one second will lock the doors. The parking lights will flash once to confirm that the doors are locked. Unlocking To unlock the doors press for one second. The parking lights will flash twice to confirm that the doors are unlocked. © 2006 Directed Electronics--all rights reserved 7 Ignition Controlled Door Locks If power door locks have been connected to your system, the vehicle's door will lock three seconds after the ignition has been turned on and unlock when the ignition is turned off. NOTE: If the ignition is turned on while the vehicle is remote engine started the doors will not lock until the remote engine start shuts off. To avoid being locked out of the vehicle, do not turn the ignition on until you are ready to drive the vehicle. remote engine This feature allows you to remotely start and run your vehicle for a programmable period of time. This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehicle with the climate control system. [. . . ] Comfort closure is a programming option which closes the vehicle's windows after remote locking. Your system can be programmed to turn on the parking lights for the entire remote engine start operation. © 2006 Directed Electronics--all rights reserved 13 Glossary of Terms Control Unit: The "brain" of your system. It houses the microprocessor which monitors your vehicle and controls all the system functions. Transmitter: A hand-held, remote control which operates the various functions of your system. 14 © 2006 Directed Electronics--all rights reserved Cut along dotted line and fold for a quick and easy reference to keep in your purse or wallet. QUICK REFERENCE GUIDE To lock the doors using your remote Pressing / for one second will lock the doors. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE CLARION RS10




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CLARION RS10 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.