User manual CLARION OHM641

[. . . ] In extremely cold temperatures, the movement of the picture may be slow and the picture may be dark, but this is not a malfunction. Small black and shiny dots inside the liquid crystal panel are normal for liquid crystal products. DESCRIPTION The OHM641 has a TFT active matrix color LCD monitor which delivers a striking picture and superior image resolution. The OHM641 can be used to enjoy video images with the Clarion VCP9600 or DVD9600, even if no TV tuner is connected. [. . . ] Place the gasket around the housing and plug the cables into the monitor. Mount the housing to the mounting bracket with the 4 machine screws provided. You can now run the IR, power and video cables to their respective destinations. If you're using the VDH9600 or DVD9600, you can make all of your connections there. PICTURE ADJUSTMENT Brightness To adjust the picture brightness, use the Brightness UP and DOWN buttons located on the front panel of the OHM641. Viewing Angle To adjust the viewing angle gently tilt the cabinet to the desired posiion. The recommended viewing angle of the unit is ­ 30 to +10 degrees vertical and +45 to ­45 degrees horizontal. 5 APPLICATIONS With the VDH9600, TTX001 and the FM100S 1. Typically the tuner will be located close to the VCP or DVD player. Avoid areas with excessive heat or moisture and mount the tuner. Plug the A/V RCA cables, IR extension and power plug into the 16 pin connector and run to the video player. Plug the Y connector into the player and plug the IR extension into the Y connector. At the OHM641, plug the IR extension and power cables supplied with the OHM641. Plug the audio RCA cable into the audio output of the player and run the audio RCA and main power cables to the radio location. Mount the switch for the FM100S and run its power wire to the radio location. The power and ground wires of the TTX001, video player, OHM641 and the FM100S can be joined and connected to the radio accessory and ground wires. The FM 100S has a two position switch to select the modulation frequency. Pick the frequency that has the least amount of radio reception and set that frequency on the modulator and into a radio preset memory. Operation Similar to a home system, the VDH9600 allow their auxiliary A/V inputs to loop through to their A/V outputs when they are not playing a video tape. · Because the IR lines have been linked together, each component can be controlled by its respective remote control when pointed to the IR eye located on OHM641. Point the video player remote at the IR eye and press power to turn on the player. Point the remote (RC-300) at the IR eye and press power to turn on the tuner. · You should now see the TV displayed on the monitor. · 6 · Turn the modulator and the radio on and tune to the modulated frequency. [. . . ] Cleaning the LCD panel: · Use a soft, dry cloth to gently wipe off any dust. · The surface is easily scratched; do not rub it with hard objects. TROUBLESHOOTING Before assuming malfunction of the unit, check the following: Problem: Power indicator LED is off. This may be due to signal interference from other cars, high voltage lines, neon lights, etc. [. . . ]