User manual CLARION OHM102

[. . . ] FCC Approval The OHM102/OHM153 has been tested and found to comply within the limits of Part 15B of the FCC rules. These limitations are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates and uses radio frequency energy and if not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. There is no guarantee that interference will not occur in a particular installation. [. . . ] Each time the MODE button is pressed, the screen mode switches in the following sequence: Note: The screen mode will set after 5 seconds, pending that the MODE button is not pressed. The display image may appear coarse or grainy when viewed in Zoom mode. Changing the Display Settings (Picture In Picture/Split Screen) The display setting can be adjusted by pressing the PIP (Picture In Picture) button on the control panel or remote control. In PIP mode, the second image can be displayed in any of the four corners and in four different viewing aspects. In split screen mode, the display is evenly divided between two AV sources. To access PIP or split screen display setting, press the PIP button until the desired mode is displayed. The screen will change in the following sequence: Selecting the AV Sources for Main and Sub Screen MAIN SCREEN Press the (DOWN Button) to select the desired AV source. The sources will be changed in following sequence: SUB SCREEN Press the (UP button) to select the desired AV source. The sources will be changed in following sequence: NOTE: Same video input cannot be viewed simultaneously. Dimmer Button: Press the DIMMER button to adjust the brightness of the screen. The brightness will change in the following sequence: OPERATING THE REMOTE CONTROL 1. FM button Press to turn ON/OFF the FM modulator (FM200 not included) 3. FM MOD ON/OFF>Brightness>Contrast>Saturation>Hue>Sub Size>Sub Position> Default Reset (Down button) MENU, then DOWN selects item to be adjusted. MAIN MODE button Press to change the screen format: Normal, Full, Zoom, and Wide. PIP button Press to select PIP (Picture In Picture) or split screen operation. SWAP button Switches the PIP (Picture In Picture) with the Sub image. SUB POS button Press to select the location of the PIP (Picture In Picture) image. SIZE button Press to select the size of the PIP (Picture In Picture) image. Mode button Press to change the screen format: Normal, Full, Zoom, and Wide. Battery Installation 1. Slide the battery-retaining clip in, while sliding the battery tray out. Insert the CR2025 lithium battery into the tray with the "+" facing upwards. Note: Under normal conditions the battery should last approximately one year. When the battery becomes weak, the transmitting range of the remote control will shorten. Replacing the battery with anything other then a CR2025 battery can damage the remote control. OPERATING THE HEADPHONES 1. The power on the headphones will turn off automatically, if an audio signal is not detected for over a minute. [. . . ] Product must be shipped in its original carton or equivalent carton, fully insured, with shipping charges prepaid. Clarion will not assume any responsibility for any loss or damage incurred in shipping. 7. ALL IMPLIED WARRANTIES EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW SHALL HAVE NO GREATER DURATION THAN THE WARRANTY PERIOD SET FORTH ABOVE. UNDER NO CIRCUMSTANCES SHALL CLARION BE LIABLE FOR ANY LOSS OR DAMAGE, DIRECT OR CONSEQUENTIAL, ARISING OUT OF THE USE OR INABILITY TO USE THE PRODUCT. [. . . ]