User manual CLARION DXZ576USB INSTALLATION GUIDE

[. . . ] Remove the stopper following the procedures below when this source unit is installed without the universal mounting bracket. This set is exclusively for use in cars with a negative ground, 12 V power supply. Be sure to disconnect the battery "-" terminal before starting. [. . . ] Insert the source unit into the universal mounting bracket until it locks. Take care of the top and bottom of the outer escutcheon and mount it so that all the hooks are locked. : The parts and SCREW with this mark are used to install radio or included in the installation kit. Note 1: In some cases, the center panel may require some modification (trimming, filling, etc. Note 2: If a hook on the installation bracket interferes with the unit, bend and flatten it with a nipper or a similar tool. Notes: 1) Some car models require special mounting kits for proper installation. 2) Fasten the front stopper securely to prevent the source unit from coming loose. When removing the source unit, disassemble it in the reverse of the order in Section "3. If it is, replace the fuse with a new one with the same amperage rating as the original one. When the CeNET extension cable is pulled, hold the slide cap part and pull it towards you. When the CeNET extension cable is extended or branches, use extension cable CCA-520 (2. When the main power supply fuse in the car is 15 A or less, purchase an automotive cable that can withstand 15 A and supply this unit with power directly from the battery to ensure that the unit will operate normally. Note that a fuse must be installed at a distance no longer than 30 cm from the cable battery terminal to prevent accidents. Bottom Outer escutcheon Outer escutcheon side view Note: Before attaching the universal mounting bracket, slightly bend the spring toward the inside with your fingers and attach it to the side of car. Example of the system using an external amplifier (Audio Visual) To external amplifier * To eliminate audio short circuits, do not remove the caps of unused RCA cables. CAUTION: Please make sure when connecting external power amplifier, that you properly, to the car chassis, ground the amplifier. [. . . ] For tough dirt, apply a little cold or warm water to a soft cloth and wipe off the dirt gentry. IMPORTANT: Improper installation may cause damage to your unit or car. If you do not have the appropriate experience, consult a qualified installer. [. . . ]