User manual CLARION DVH943

[. . . ] Some tracks may sound distored when adjustment; this is normal and not a cause for concern. Using the newest in digital matrix technology, Dolby Pro Logic II is a matrix decoder technology which further improves earlier Dolby Pro Logic. Four modes can be set in accordance with the playback source, including MUSIC mode, MATRIX mode, MOVIE mode, and VIRTUAL mode. 1 channel are recorded discretely, so no crosstalk occurs between channels, and the sense of placement and depth of the sounds is reproduced faithfully. [. . . ] The normal setting is [ON+], but use the [ON-] setting when this provides a better effect for low frequency range. Turn the [ROTARY] knob clockwise or counterclockwise to adjust each value. The timing when the sound of each speaker reaches the listening position depends on speaker installation and the size of the car. Adjust the delay time of each speaker so that the sound of all speakers reach the listening position at the same time as the sound from the front speakers. A speaker that was turned off in the Section "Turning speakers on or off (SP-SEL)" is not displayed. Press and hold the [ADJ] button for 1 second or longer to enter adjust mode. Use the built-in test tone function of the unit to adjust the speaker output level to the same level. A speaker that was turned off in the Section "Turning speakers on or off (SP-SEL)" is not displayed. Press and hold the [ADJ] button for 1 second or longer to enter adjust mode. This function is used to set a filter frequency that suits the frequency characteristics of the used speakers. A speaker that was turned off in the Section "Turning speakers on or off (SP-SEL)" is not displayed. Press and hold the [ADJ] button for 1 second or longer to enter adjust mode. This function compresses the dynamic range of Dolby Digital to maintain low level sounds such as actor conversation and suppress loud sound volumes. Press and hold the [ADJ] button for 1 second or longer to enter adjust mode. Turn the [ROTARY] knob clockwise or counterclockwise to select the value from [MAX], [STD] or [MIN]. MIN: the most compressed dynamic range mode that renders even low sounds easy to hear. CTR WIDTH (0 to 7): Selecting CTR WIDTH mode will adjust the localization of the centre channel between the centre speaker and the front speaker L/R. Distributing the centre channel sound to the right and left will increase the integrated sound field image, providing you with an natural spatial feeling of sound. setting to the value 0 will produce the centre sound with the centre speaker. Setting to the value 7 will distribute the centre sound to the front speaker L/R as the existing stereo sound does. When MUSIC Mode has been selected on the PL II menu, finer adjustments can be made when desired. CTR WIDTH is not available when centre speaker is turned off in the section "Turning speakers on or off (SP-SEL)". [. . . ] The main unit's case has been provided with 3 screw holes on either side. Position the unit on the floor mat, then mark and open holes in the floor mat so they are aligned with the mounting bracket's holes. Press the accessory canoe clips from the underside upward through the mat and into the mounting bracket holes. Route the CeNET cable with plenty of extra room so that the connector will not become disconnected accidentally. [. . . ]