User manual CLARION CJ981E

[. . . ] Owner's manual & Installation manual Mode d'emploi et manuel d'installation Bedienungs- & Installationsanleitung Manuale d'Istruzioni e d'Installazione Thank you for purchasing this Clarion product. Please read this owner's manual in its entirety before operating this equipment. After reading this manual, be sure to keep it in a handy place (e. g. , glove compartment). Check the contents of the enclosed warranty card and keep it carefully with this manual. English Français English Contents 1. [. . . ] The scale markers have been designed based on the "CCD camera installation conditions" listed in the next section, but differences in vehicle design and construction may result in the actual installation condition or location being different from the conditions listed. In such cases, the display location should be set at the closest marker No. · Do not set or use scale markers when using a CCD camera made by a company other than Clarion. Notes: · Different camera types produce different patterns of scale marker. Be sure to set the camera function (CAM TYPE) before setting the markers in this section (MARKER). · The markers are not designed to ensure safety by indicating the actual position of the bumper, the vehicle's width or the distance to the rear. Press the [MODE] button to switch to the "MARKER SELECT" menu. Each time the [MODE] button is pressed, the mode cycles through the modes in the order "CAM" "MARKER" . . . "CAM". Vehicle width (From bumper toward rear) MARKER SELECT P1 7m 5m 3m 1m Bumper position ICCD camera installation conditions (scale marker input conditions) Unit: mm Marker No. (Pattern) P1 P2 P3 P4 P5 P6 P7 Camera Install Height 2000 2250 2500 2750 3000 3250 3500 Vehicle Width 2500 2. Each time the [MODE] button is pressed, the mode cycles through the modes in the order "CAM" "MARKER" . . . Press the [MODE] button to return to the "CAM" mode screen. 2300 2500 4. · When the [z] button is pressed, the marker pattern cycles in descending order, from P1 P7 P6 . . . · When the [w] button is pressed, the marker pattern cycles in ascending order, from P1 P2 P3 . . . 8 CJ-981E Adjusting the Bumper Position (MARKER ADJUST) MARKER SELECT English P1 MARKER SELECT P1 MARKER SELECT P7 MARKER SELECT P2 MARKER SELECT P6 MARKER SELECT P3 MARKER SELECT P1 MARKER SELECT P7 5. Press the [MODE] button to return to the "CAM" mode screen. The display position of the scale markers set on the screen can be adjusted to more closely match the actual position of the vehicle's bumper. Note: · Different camera types are equipped with different scale marker patterns. Be sure to set the "CAM TYPE" first, and only then set the marker adjust. Press the [FUNC] button and switch to the "CAM" mode screen. Press the [MODE] button and switch to the "MARKER ADJUST" setting menu. Each time the [MODE] button is pressed the menu alternates in the following order: "CAM" "MARKER" . . . Press the [z] and [w] buttons as required to adjust the scale marker position up/down. · The marker display position can be moved 10 steps above (V+1 to +10) and 10 steps below (V-1 to -10) the default position. · When the markers are moved from their default position, the more the onscreen markers move, the more they vary from representing their actual physical position. [. . . ] Lift up the guide holder while pressing down on the unlock knob to remove the guide holder. Guide holder Adjust the angle of the stand. Stand base Guide holder Unlock knob 4. Align the stand base with the profile of the attachment surface and bend the stand base. Notes: · Bend the stand base so that it contact-fits the profile of the attachment surface. Gaps in the attachment may cause the stand base to come away from the attachment surface. [. . . ]