User manual CITIZEN SLD-2010

[. . . ] Operating Environment · USB-supported PC operating on any of the following operating system. Microsoft Windows XP, 2000, Me, 98SE, 98 · USB is operating normally. As shown in the following figure, "Universal Serial Bus controller" must be displayed. [. . . ] As shown in the following figure, "Universal Serial Bus controller" must be displayed. Also if "×"or "!" is shown on the Host Controller or USB route hub shown under the display, the USB is not active and printing through USB is not possible. 1 4. Connect USB series B plug to the printer. Type A connector Type B connector 5. Setting up the Driver To allow the USB printer to print on Windows, it is necessary to install the USB driver and printer driver. For installation of printer driver, read the description supplied with the driver. Before installation, prepare both drivers. 5. 1 Installation on Windows XP Connect the PC and the printer together using the USB cable while Windows XP is operating. (All other programs shall be terminated to secure normal installation. ) The printer USB interface is automatically identified and a message "Installing new hardware. " is displayed at the right bottom of the screen. Following the USB driver installation, installation of the printer driver starts. Set the floppy disk containing the driver and then click [Next]. The following window is displayed. Click [Next]. 4 Click [Finish] on the following window to complete the USB driver installation. Then installation of the printer driver starts. About USB port If more than one USB connector is present on the PC, replacing the USB cable of the same printer to another USB connector may allow the port to be recognized as another USB port. If the combination of the connector connected to the cable and the USB port selected by the printer driver is not correct, printing is not possible. 6. Precautions on Sequence of Power ON Always turn on the PC and then the printer. If more than one USB printer is connected to one PC, the USB port number is assigned in the order of connection. If you want to use the same USB port number assigned to the printer, it is necessary to make the order of turning on the printers same at all times. 7. (No consumption when printer power is off. ) Interface with main board: Complies with our parallel board (USB--IEEE1284 conversion) Transmission speed: Full speed mode (12 Mbps) Communication system: Bidirectional bulk transmission Buffer memory: 512 bytes (data amount of up stream and down stream in all) Dimensions: 70 × 40 mm (Excluding protruded part of connector) Operating environment: 5 to 40°C, 35 to 85% RH (without condensation) Storage environment: -10 to 50°C, 10 to 90% RH (without condensation) 5 Connector: Pin assignment of USB connector is shown in the following table. Pin No. [. . . ] If more than one USB printer is connected to one PC, the USB port number is assigned in the order of connection. If you want to use the same USB port number assigned to the printer, it is necessary to make the order of turning on the printers same at all times. 7. (No consumption when printer power is off. ) Interface with main board: Complies with our parallel board (USB--IEEE1284 conversion) Transmission speed: Full speed mode (12 Mbps) Communication system: Bidirectional bulk transmission Buffer memory: 512 bytes (data amount of up stream and down stream in all) Dimensions: 70 × 40 mm (Excluding protruded part of connector) Operating environment: 5 to 40°C, 35 to 85% RH (without condensation) Storage environment: -10 to 50°C, 10 to 90% RH (without condensation) 5 Connector: Pin assignment of USB connector is shown in the following table. Pin No. [. . . ]