User manual CITIZEN SLD-200

[. . . ] This digital apparatus does not exceed the class A limits for radio noise emissions from digital apparatus, as set out in the radio interference regulations of the Canadian department of communications. 1 The information contained herein is subject to change without prior notice. Reproduction of part or all of this document is prohibited without written permission from CBM Corporation. 3 Except explained elsewhere in this manual, do not attempt to service, disassemble or repair this product by yourself. [. . . ] Avoid using torn pieces of paper or spliced with plastic adhesive tapes. To release, refer to "Removing Jammed Paper" in this manual. Q Neglecting these cautions may result in printer malfunction or failure. Be careful that the printer cover does not entrap your hands or fingers. Paper cutter, gears, active electrical parts) while the printer is working. Q If the printer emits smoke, an odd smell, or unusual noise while printing, immediately abort the current print session and unplug the printer from the supply outlet. When cleaning the printer, always turn it off and unplug it from the supply outlet. Never use organic cleaning solvent such as alcohol, paint thinner, or benzen. When transporting the printer, remove the roll paper from its paper holder. When cleaning the thermal head surface, use a cotton gauze slightly dampened with alcohol. Do not touch the thermal head's printing surface with bare hand or a metallic implement. Wipe off stains, such as dust and the like, on the heating element of the head using a cotton swab soaked in ethyl alcohol. Do not touch the heating element of the head with a bare hand or metal object either. It also blinks while the printer is waiting for a macro to be executed. FEED switch Pressing this switch briefly causes one line of paper feeding. While a macro is waiting to be executed, pressing the switch causes the macro to be executed. Lights Quick and slow blinking Three long beeps -- Slow blinking Lights Lights -- Lights Quick and slow blinking Memory Check error: This error occurs if a memory read-after-write check or FROM sum check has resulted in an error (unrecoverable error). Cover open: When you open the printer cover, the cover open sensor is activated, causing the ERROR lamp to light and the printing operation to stop. (Not recoverable error) Head overheat: To protect the print head from overheating, the head temperature sensor is activated if the head temperature rises over approx. 65°C , causing the ERROR lamp to blink and the printing operation to stop. Printing resumes automatically when the head temperature lowers below approx. (Auto recoverable error) Paper near-end: As the paper roll diameter becomes small, the Paper near-end sensor is activated and causes the ERROR lamp to light, indicating the paper supply has become low. [. . . ] (Siehe , , Selecting the paper sensor valid for paper end signal output" und , , Selecting the Paper-Near End Sensor valid for print stop". ) Papierende: Wenn das Papier abgelaufen ist , spricht ein nahe am Druckkopf über dem Papierweg befindlicher Sensor an , woraufhin die Fehler-LED aufleuchtet und der Druckvorgang stoppt. (Siehe , , Selecting the paper sensor valid for paper end signal output" und , , Selecting the Paper-Near End Sensor valid for print stop". (Vedere "Selecting the paper sensor valid for paper end signal output" e "Selecting the Paper-Near End Sensor valid for print stop". [. . . ]