User manual CITIZEN CT915

[. . . ] INSTRUCTION MANUAL FOR CT915 SAFETY PRECAUTIONS WARNING Keep the battery away from infants. Measure temperature according to directions given by a doctor and consult him (her). CAUTION Do not disassemble the thermometer. Do not leave the thermometer in a place where it will be exposed to high temperature or direct sunlight or where the ambient temperature will be below 0°C or the humidity is high. - Eng 2 - FEATURES OF CT915 CT915 records measurement results automatically. Basal body temperature recording mode or all-measurements recording mode can be selected. [. . . ] If the POWER/MEASURE switch is not pushed, the record display screen appears automatically and the power is turned off 30 more seconds after. English basal * In the for thebody temperature recording mode, the temperature measured first time on each day is recorded automatically, but the temperatures measured for the second time and after on the same day are not recorded automatically. When recording the temperature measured for the second time or after, push the SET switch while the measurement finish screen is displayed, and the record is rewritten. - Eng 13 - ALL-MEASUREMENTS RECORDING MODE 1. Remove the probe from the body 1) Open the cover and push the rear end of the probe lightly to remove the probe from the hook. Measure the body temperature Method of measuring body temperature (Allmeasurements recording mode) 1) Push and hold the POWER/MEASURE switch for a while (about 1 second) to turn on the power. When the power switch is pressed ON, the display will read as a check that all part of the display is working (Safety test for system). Measurement Screen No display of LADY Measurement mark - Eng 14 - 2) Then, push the POWER/MEASURE switch momentarily to display the measure screen. * If the POWER/MEASURE switch is pushed and held for a while (about 1 second), the power is turned off. When displaying the measure screen while the power is turned on, push and release the POWER/MEASURE switch quickly. * To change the basal body temperature recording mode ( LADY is displayed) to the all-measurements recording display ( LADY is not displayed), repeat the operation of "Setting alarm, time, date, and mode" (on pages 6-10) from the first, then select the all-measurements recording mode. 3) Place the sensor of the probe under your tongue to start measurement. If peeps are heard, the measurement is in error ("E" is displayed). In this case, push the POWER/ MEASURE switch again and start measurement. When more pips are heard about 5 minutes after measurement is started, measurement is finished. * The first electronic pip indicates that the temperature is being measured normally. Ending of measurement English - Eng 15 - 5) In the all-measurements recording mode ( LADY is not displayed), all the measured temperatures are recorded automatically. * Even in the basal body temperature recording mode ( LADY is displayed), you can measure your body temperature by the above method. Your body temperatures measured after your basal body temperature is measured are not recorded, however. 3. Store the probe in the body 1) Wipe off saliva with tissue paper, etc. How to turn off the power Push and hold the POWER/MEASURE switch for a while (about 1 second) to turn off the power. If the POWER/MEASURE switch is not pushed, the record display screen appears automatically and the power is turned off 30 more seconds after. - Eng 16 - READING RECORDS/CHECKING GRAPH You can check the change of your body temperatures in 31 days (31 measurements) at a glance. 1) Push and hold the POWER/MEASURE switch for a while (about 1 second) to turn on the power. (The record display screen appears. ) 2) The temperatures recorded up to now are displayed in graph on the lower graph display unit. In the upper value display unit, the temperature and the date of the blinking bar are displayed alternately. English - Eng 17 - 3) Move the graph forward or in reverse with the right (s) or left (t) shift switch and check the temperature and date of each bar displayed on the value display unit. [. . . ] Do not pull the cord more than necessity or swing the body with the cord. Keep the thermometer away from children since it can injure them and can be damaged. Do not use paint thinner, benzene, or cresol water to clean the thermometer. Do not clean the thermometer with water, hot water, or ultrasonic cleaner. [. . . ]