User manual CITIZEN CT-S801

[. . . ] En If you want to dispose of this product, do not mix it with general household waste. There is a separate collection systems for used electronics products in accordance with legislation under the WEEE Directive (Directive 2002/96/EC) and is effective only within European Union. This printer conforms to the following Standards: This declaration applies only to the 230-V model. IMPORTANT: This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual, may cause interference to radio communications. [. . . ] Settings remain stored in the memory even if the printer is turned off. For the built-in power type printer, connect the AC power cord to the AC inlet, and insert the plug into an electric outlet. for the AC adapter type printer , connect the cable connector of the AC adapter to the power connector. Next, connect the AC power cord to the AC inlet, and insert the plug into an electric outlet. AC adapter AC inlet AC power cord Built-in power supply type AC power cord AC adapter type Use only an AC adapter that complies with the specified ratings. Always hold the AC adapter's cable connector by the connector when removing or inserting it. Use an AC power source that does not also supply power to equipment that generates electromagnetic noise. Pulling on the AC power cord may damage it, cause a fire, electric shock, or break a wire. If a lightning storm is approaching, unplug the AC power cord from the electric outlet. The insulation on the AC power cord may melt and cause a fire or electric shock. If the printer is not going to be used for a long time, unplug the AC power cord from the electric outlet. Ethernet and powered USB interfaces are available as options in addition to those listed here. Be careful not to insert the USB interface cable into the cash drawer kick-out connector. To connect more than one printer to a single computer via a USB interface you must change the serial number of the USB interface. Confirm the orientation of the cash drawer kick-out cable connector and connect it to the cash drawer kick-out connector at the back of the printer. Screw for ground wire Connect only the cash drawer kick-out cable connector to the cash drawer kick-out connector. ) Signals cannot be output from the cash drawer kick-out connector while printing. 1 2 3 4 5 6 Signal FG DRAWER1 DRSW VDR DRAWER2 GND Function Frame ground Cash drawer 1 drive signal Cash drawer switch input Cash drawer drive power supply Cash drawer 2 drive signal Signal ground (common ground on circuits) Connector used: TM5RJ3-66 (Hirose) or equivalent Applicable connector: TM3P-66P (Hirose) or equivalent 3 V (3) DRSW signal DRSW signal status can be tested with the DLE+EOT, GS+a, or GS+r command or at pin 34 on the parallel interface port. Cash drawer open/ close switch Cash drawer Printer Cash drawers 1 and 2 cannot be operated at the same time. Use only the specified external device cable to connect to the external device connector (do not use phone, LAN, or USB cables). Signal 1 2 3 4 FG TXD RXD DSR I/O -- Input Input Frame ground Data received from external device Indicates that the printer can receive data. MARK: Printer cannot receive SPACE: Printer can receive Function Connector used: RJ-45 Applicable connector: RJ-45 MARK: External device cannot receive SPACE: External device can receive -- -- -- Signal ground (common ground on circuits) Power supply terminal (24 VDC) Flyback line for power supply The printer can be used horizontally, vertically, or installed on a wall. [. . . ] 3 Clearing a Cutter Lock (2) Head overheat When you print dense characters, dark images, or for an extended time in a hot environment, the print head temperature increases. If the print head exceeds a specified temperature, the printer stops printing and waits for the print head to cool. The LCD's top line is the type of error, the bottom line is the remedy. Status Paper near-end Paper-end Front cover open Paper cover open Cutter locked Front cover open Please close front cover. [. . . ]