User manual CITIZEN CT-S651

[. . . ] En If you want to dispose of this product, do not mix it with general household waste. There is a separate collection systems for used electronics products in accordance with legislation under the WEEE Directive (Directive 2002/96/EC) and is effective only within European Union. This printer conforms to the following Standards: This declaration applies only to the 230-V model. IMPORTANT: This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual, may cause interference to radio communications. [. . . ] Settings remain stored in the memory even if the printer is turned off. For the built-in power type printer, connect the AC power cord to the AC inlet, and insert the plug into an electric outlet. for the AC adapter type printer , connect the cable connector of the AC adapter to the power connector. Next, connect the AC power cord to the AC inlet, and insert the plug into an electric outlet. AC adapter AC inlet AC power cord Built-in power supply type AC power cord AC adapter type Use only an AC adapter that complies with the specified ratings. Always hold the AC adapter's cable connector by the connector when removing or inserting it. Use an AC power source that does not also supply power to equipment that generates electromagnetic noise. Pulling on the AC power cord may damage it, cause a fire, electric shock, or break a wire. If a lightning storm is approaching, unplug the AC power cord from the electric outlet. The insulation on the AC power cord may melt and cause a fire or electric shock. If the printer is not going to be used for a long time, unplug the AC power cord from the electric outlet. Always unplug the AC adapter from the printer before connecting the printer to a Powered USB interface. For information about installing a Powered USB interface, contact your Citizen Systems dealer. check the orientation of the Powered USB cable connector before connecting it. Be careful not to insert the USB interface cable into the cash drawer kick-out connector. To connect more than one printer to a single computer via a USB interface you must change the serial number of the USB interface. hold the connector of the Ethernet interface cable perpendicular and straight when connecting or disconnecting it. Use a serial interface cable with the connection layout shown below. Confirm the orientation of the cash drawer kick-out cable connector and connect it to the cash drawer kick-out connector at the back of the printer. Screw for ground wire Connect only the cash drawer kick-out cable connector to the cash drawer kick-out connector. ) Signals cannot be output from the cash drawer kick-out connector while printing. Hold the connector of the drawer kick cable perpendicular and straight when connecting or disconnecting it. [. . . ] A selection is printed in order through the cycle each time the FEED button is pressed. If there is another selectable item, it and the selection are printed. Repeat steps 4 and 5 to select and set the printer's model, paper width, character spacing (EPSON T88 only). The changed memory switch settings are saved and a list of them is printed. [. . . ]