User manual CITIZEN CT-S601

[. . . ] En If you want to dispose of this product, do not mix it with general household waste. There is a separate collection systems for used electronics products in accordance with legislation under the WEEE Directive (Directive 2002/96/EC) and is effective only within European Union. This printer conforms to the following Standards: This declaration applies only to the 230-V model. IMPORTANT: This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual, may cause interference to radio communications. [. . . ] Always hold the AC adapter's cable connector by the connector when removing or inserting it. Use an AC power source that does not also supply power to equipment that generates electromagnetic noise. Pulling on the AC power cord may damage it, cause a fire, electric shock, or break a wire. If a lightning storm is approaching, unplug the AC power cord from the electric outlet. The insulation on the AC power cord may melt and cause a fire or electric shock. If the printer is not going to be used for a long time, unplug the AC power cord from the electric outlet. Ethernet and Powered USB interfaces are available as options in addition to those listed here. Always unplug the AC adapter from the printer before connecting the printer to a Powered USB interface. For information about installing a Powered USB interface, contact your Citizen Systems dealer. Be careful not to insert the USB interface cable into the cash drawer kick-out connector. To connect more than one printer to a single computer via a USB interface you must change the serial number of the USB interface. Confirm the orientation of the cash drawer kick-out cable connector and connect it to the cash drawer kick-out connector at the back of the printer. Screw for ground wire Connect only the cash drawer kick-out cable connector to the cash drawer kick-out connector. ) Signals cannot be output from the cash drawer kick-out connector while printing. 1 2 3 4 5 6 Signal FG DRAWER1 DRSW VDR DRAWER2 GND Function Frame ground Cash drawer 1 drive signal Cash drawer switch input Cash drawer drive power supply Cash drawer 2 drive signal Signal ground (common ground on circuits) Connector used: TM5RJ3-66 (Hirose) or equivalent Applicable connector: TM3P-66P (Hirose) or equivalent 3 V (3) DRSW signal DRSW signal status can be tested with the DLE+EOT, GS+a, or GS+r command or at pin 34 on the parallel interface port. Cash drawer open/ close switch Cash drawer Printer Cash drawers 1 and 2 cannot be operated at the same time. The printer can be used horizontally, vertically, or installed on a wall. However, the CT-S601S (built-in power supply type) cannot be used vertically or installed on a wall. Use the optional stand for vertical applications, and the optional brackets for wall installations. Change the paper near-end sensor settings for vertical and wall installations. (The factory setting for the paper near-end sensor is for horizontal installations. Locations that are very dirty or dusty Locations where the printer is not level. [. . . ] Quick setting mode The settings for the memory switches for a replacement printer's manufacturer, model, paper width, and character spacing can be set at the same time to the optimum settings. While the paper cover is open, press and hold the FEED button while turning the power on. A selection is printed in order through the cycle each time the FEED button is pressed. If there is another selectable item, it and the selection are printed. [. . . ]