User manual CITIZEN CT-S2000DCL

[. . . ] 4. 6 Error Indication The following LED indications are added to CT-S2000L/CT-S2000DCL. Status Wait for cutting label Paper detection error POWER LED OFF OFF ERROR LED Buzzer LINE THERMAL PRINTER MODEL CT-S2000L/CT-S2000DCL User's Manual Refer to CT-S2000/CT-S2000DC User's Manual of standard model when reading this manual. 5. 3 Manual Setting of Memory Switch Functions of memory switches SW4-1, SW4-2, SW4-4, SW4-5 and SW4-6 of CT-S2000L/ CT-S2000DCL are as shown below. (The white-on-black characters are factory setting. ) Memory Switch SW4-1 SW4-2 SW4-4 SW4-5 SW4-6 Function Paper Length Setting Top of Form at Power ON Paper Select Position Detect Paper Change 0 (OFF) Auto Measure Invalid Thermal Roll Black Mark Invalid 1 (ON) Command Valid BM. P/Lbl. P * Label Valid Contents 1. 1 4. 6 5. 3 5. 4 5. 5 5. 6 Features Error Indications Manual Setting of Memory Switch Selecting Paper Type Adjusting the Sensitivity of Paper Sensor Printing Paper * When printing on label paper, adjust the layout so that right and left margins are 4 mm or more. [. . . ] Press the FEED button to match the paper type loaded to the LED indications in the table below. (Refer to the table below. ) Label light emitting sensor POWER LED Label Thermal paper roll Black mark paper Green lit (OFF) Green lit ERROR LED (OFF) Red lit Red lit Label light receiving sensor Black Mark sensor(BM1) 3 Save the selected Paper Type to the Printer. By this operation, selected paper type is stored in the printer memory and the Selecting Paper Type mode is terminated. Since then, "P. Length Set" of Memory switch 4-1 becomes disable. When closing the printer cover during the setting a black mark paper or label paper in the printer, paper length is measured, and the result will be printed out. * When paper detection error occurs at the measurement of paper length, automatically enters paper sensor adjustment mode. Adjust the sensor in accordance with "5. 5 Adjusting the Sensitivity of Paper Sensor". Black Mark sensor(BM2) Black Mark sensor(BM3) 5. 5 Adjusting the Sensitivity of Paper Sensor Before using black mark paper (BM paper) or label paper, adjust the sensitivity of the paper sensor by using actual paper. Open the printer cover, remove paper, and then set the printer power switch to ON. In case of label, set it so that label is positioned on the label light receiving sensor and label light emitting sensor. In case of black mark paper, set it so that the printable portion (other than black mark) is positioned on the black mark sensor. With this state kept, closing the printer cover causes ERROR LED to blink with the buzzer sound. 3 Adjust the sensitivity of the paper sensor and measure the length of paper. Pressing the FEED switch causes label to be fed and paper sensor sensitivity adjustment and paper length measurement are carried out automatically. [. . . ] Refer to the above drawing for the printable area and have enough margings specified in the marks E and G. If the print data size is out of the printable area, the printer should skip to next page. TA74912-00F 1. 00E-0710 Printed in Japan [. . . ]