User manual CITIZEN CH607

[. . . ] Wind the cuff around the wrist and tighten it so that one finger may be inserted between the cuff and wrist. · When you feel like relieving yourself, you should do so before measuring blood pressure. - Eng 2 - · Measure blood pressure where the room temperature is about 20°C. DO NOT measure blood pressure when it is too cold (below 10°C)or too hot (above 40°C) in the room . [. . . ] Replace the two batteries, matching the (+) and (­) polarities on each battery with the polarity marks on the case. · To take the batteries out easily, pull the transparent ribbon. "LR03" batteries or equivalent are suitable for this blood pressure monitor. Do not mix alkaline, standard (carbon-Zinc) or rechargeable (cadmium) batteries. Default time indicating state and selection of each mode When the battery is installed, the time and date are set as follows. Setting Date and Time 1) Press the "Mode" switch then "Month" starts flashing and press "SET" button to set the correct month. (Each time the "Set" switch is pressed, the value of the month is increased - Eng 8 - by one. The value of minute can be corrected in only the forward direction. ) 2) Press the "Mode" switch then "Date" starts flashing. (Each time the "Set" switch is pressed, the value of the date is increased by one. The value of hour can be corrected in only the forward direction. ) 3) Press the "Mode" switch then "Hour" starts flashing. (Each time the "Set" switch is pressed, the value of the Hour is increased by one. The value of hour can be corrected in only the forward direction. ) 4) Press the "Mode" switch then "Minute" starts flashing. (Each time the "Set" switch is pressed, the value of the minute is increased by one. The value of Minute can be corrected in 12-hour format in only the forward direction. ) 5) Press the mode switch to finish correction. English Español Português Italiano MEASUREMENT PROCEDURES 1. [. . . ] After, wind the wristlet around your left wrist. Français - Eng 11 - 5. Memory recall You can recall stored data by pressing the "Memory" switch, except when performing a measurement. · Up to 99 sets of measurement results are automatically stored in memory, and memory cell No. [. . . ]