User manual CITIZEN CALIBER NO 0855

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CITIZEN CALIBER NO 0855. We hope that this CITIZEN CALIBER NO 0855 user guide will be useful to you.


CITIZEN CALIBER NO 0855 : Download the complete user guide (602 Ko)

Manual abstract: user guide CITIZEN CALIBER NO 0855

Detailed instructions for use are in the User's Guide.

[. . . ] When charging the secondary battery, do not pull it too close to the light source. * When charging the watch under direct rays of the sun, charge more than an hour. An Eco Drive Rechargeable battery is used in this watch to store electrical energy. This rechargeable battery is a clean energy battery which doesn't use any toxic substances such as mercury. [. . . ] 1)Press button (M) to set the mode hand to <ALM> and switch to the alarm mode. 3)Press buttons (B)or (C) to set the minute, hour and 24-hour hands to the desired time. The watch advances 1 minute in a clockwise direction Each time button (P is pressed . . . The watch turns back in 1 minute increments in a counter clockwise direction Return to Table of Contents Return to Table of Contents Depress button (B) or (C) continuously, the hands move rapidly. The hour, minute and 24hour hands move rapidly automatically to the present time. Switching the alarm ON and OFF Each time button (A) is pressed in the alarm mode, the alarm switches ON and OFF Alarm sound monitor On the alarm mode (button (M) in the normal position), press button (A) and the alarm will sound for 5 seconds. Note * There may be some variation in the volume of the alarm sound, depending on how much the Eco Drive Rechargeable battery is charged. * The alarm sound volume gets rather lower in the display other than the time display (alarm, chronograph, "O" position confirmation, and each display's adjustment state). Once the alarm time has been set, use the watch normally in time display mode. 4) USING THE CHRONOGRAPH Chronograph measurement is taken in 1/20 (0. 05) seconds and can continue for 60 minutes max. Chronograph measurement Chronograph reset Read the chronograph hands For measurement less than 1 minute Second hand -> Chronograph second hand Function hand -> Chronograph 1/20 second hand For measurement over 1, minute: Second hand -> Chronograph second hand Function hand -> Chronograph minute hand Return to Table of Contents Return to Table of Contents Chronograph measurement Chronograph standard or accumulated elapsed time measurement. 1) Press button (M) to set the mode hand <CHR> and get the chronograph display. At this time, the second hand and the function hand will return to the "O" position. 2) Each time button (A) is pressed, it repeatedly starts or stop the chronograph, along with a confirmation sound. How to read each chronograph hand if the measured time when the chronograph is stopped is over 1 minute. While pressing button (B) continuously, the function hand switches to 1/20 (0. 05) second hand measurement, so read the value at that time. When button (B) is released, the function hand resumes showing chronograph minutes. 3) While the chronograph is stopped state, pressing button & reset the function hand and the second hand to the "O" position. Chronograph split measurement Pressing button (C) during chronograph measurement causes the chronograph split time to appear on display with a beep for confirmation. Press button (C) again, the next chronograph split time is displayed, along with a confirmation sound. The split time display is automatically cancelled after about 10 second, and the chronograph return to the measurement state. During either chronograph split time display or measurement, pressing button (A) causes the chronograph stop to appear on display. In the chronograph stop state, pressing button (C) causes the chronograph reset. [. . . ] Any moisture should be blotted with a soft dry cloth or paper towel and the strap allowed to dry naturally. Salt residue and soil can be removed from the leather by cleaning with a dampened soft cloth and mild soap or saddle soap. Occasionally, the inside surface of the strap should be cleaned by using a soft cloth dampened with alcohol. The strap should always be worn a little loosely (one finger space between wrist and strap) to allow air to circulate thus causing any moisture to evaporate. RUBBER Rubber straps should be washed frequently with mild soap and warm water using a soft brush. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE CITIZEN CALIBER NO 0855




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CITIZEN CALIBER NO 0855 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.