User manual CITIZEN CALIBER NO 0580

[. . . ] (Time setting warning display) * The hour, minute and 24-hour hands run at the incorrect time. When the secondary battery is fully recharged, the overcharging prevention function works so that the secondary battery is not overcharged. NOTES ON USE Please take care to charge your watch during use. Please note that if you wear long sleeves, the watch can easily become insufficiently charged because it is hidden and not exposed to light. · When you take off the watch, try to place it in as bright a place as possible, and it will always continue to run properly. [. . . ] If the alarm is ON, it will ring at the set time for 15 seconds once every day. Measures up to a maximum 60 minutes in 1/20 seconds, and displays split times. A confirmation rings when you start/stop or measure a split time. SETTING THE TIME Check that the mode hand is indicating <TME> and the watch is in time mode. Pull the button M out, so that the second hand stops at the "0" position. When the watch is adjusted by button operation, the time setting is completed by electromagnetic correction. When adjusting the hour hand, check the 24-hour hand position (am/pm). Each time button B is pressed. . . The watch advances 1 minute in a clockwise direction. Each time button C is pressed. . . The watch turns back 1 minute in a counterclockwise direction. After setting the time, push the button M to the normal position and the watch will start at the correct time. SETTING THE CALENDAR Press button M to switch to calendar mode <CAL>. Correction can be made by advancing by one month each time button A is pressed. (Example: 3:00 March, 1:00 January) Correction can be made rapidly by holding button A down. 3. How to read each chronograph hand if the measured time when the chronograph is stopped is over 1 minute. Read the number of minutes with the function hand Read the number of seconds with the second hand. While pressing button B continuously, the function hand switches to 1/20 (0. 05) second hand measurement, so read the value at that time. When button B is released, the function hand resumes showing chronograph minutes. While the chronograph is stopped state, pressing button C resets the function hand and the second hand to the 0 position. Chronograph Split Measurement Pressing button C during chronograph measurement causes the chronograph split time to appear on display with a beep for confirmation. Press button C again, the next chronograph split time is displayed, along with a confirmation sound. The split time display is automatically cancelled after about 10 seconds, and the chronograph returns to the measurement state. During either chronograph split time display or measurement, pressing button A causes the chronograph stop to appear on display. In the chronograph stop state, pressing button C causes the chronograph reset. * During split time measurement or while split time display, each time you press button C the next split time is displayed. IN THESE CASES When shown the Insufficient Charge Warning Display If the watch is put in the undercharged state during any display mode, it switches to the time display when in other display modes, then the second hand moves to the CHARGE position, indicating insufficiently charged. [. . . ] To help prevent this from happening, turn the crown freely back and forth occasionally while it is in the normal set position. Wipe off any water and moisture that adheres to the case, glass and band with a soft, clean cloth. A watchband will easily become soiled with dust and perspiration because it is in direct contact with the skin. Even a stainless or gold-plated band may begin to corrode if it has not been cleaned for a long period of time. [. . . ]