User manual CHARTER OAK SA538

[. . . ] Step 2 Changing your Computer’s Wireless Settings to configure the NC-7100w Before you can use the printer in a wireless network, the NC-7100w wireless print server must be configured to match your network configuration. To configure the NC-7100w from a wireless computer on your network, you must temporarily change your current wireless settings. Before changing the current wireless settings of your PC, we recommend you make a note of your current wireless network settings using the chart on the right. We recommend you to contact your network administrator if you need assistance with your computers wireless settings. [. . . ] 2 Reset the print server back to its default factory setting and try again. See Other Information in this Quick Setup Guide for information how to reset to factory default setting. 3 Refer to Chapter 10 of the NC-7100w Network User’s Guide on the CD-ROM we have supplied with NC-7100w. Continue to Step 3 6 If the Brother wireless print server you want to choose is not listed, follow these steps: 1 Move your printer with the wireless print server installed closer to your PC, or reorient the print server and try again. 2 Reset the print server back to its default factory setting and try again. See Other Information in this Quick Setup Guide for information how to reset to factory default setting. 3 Refer to Chapter 10 of the NC-7100w Network User’s Guide on the CD-ROM we have supplied with NC-7100w. Step 3 Configuring the Print Server 1 Insert the CD-ROM into your CD-ROM drive. 3 users) Double-click the NC7100w icon on your Macintosh®, and then double-click the Start Here icon. 5 Review the Welcome information and when you are sure you have completed the necessary tasks, click Next. 2 7 English 6 The search will display a list of found Brother Wireless Devices. 13 Using the information you recorded in Step 2, return the wireless settings of your computer back to their original settings. 2 You can also configure the NC-7100w from the control panel of the printer, or using the BRAdmin utilities or a web browser. See Appendix B of the NC-7100w Network User’s Guide for more details. (For Windows® users) Refer to P19 to P23 ot the Printer Quick Setup Guide for the rest of the steps. You can find the MAC address by printing out the Network Configuration Page. See Other Information in this Quick Setup Guide for information how to print the Network Configuration Page. 4 or greater users: If you want to connect your printer using the Simple Network Configuration capabilities of Apple® Mac OS® X, select Rendezvous and then the HL-6050D_DN series. 6 Enter the TCP/IP address of the printer into the Printer’s Address box. You can find the TCP/IP address by printing out the Network Configuration Page. See Other Information in this Quick Setup Guide for information how to print the Network Configuration Page. 73 5 Anslut kontakten till skrivarservern NC-7100w ordentligt till uttaget på huvudkontrollerkortet, genom att rikta in de två skruvarna med skåran på skrivaren, och därefter fästa den med de två skruvarna. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ■ ■ ■ ■ Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. important Changes or modifications not expressly approved by Brother Industries , Ltd. [. . . ]