User manual CHAMBERLAIN VSL595 LEARN INSTRUCTION

[. . . ] SL595 Variable Speed Motor Learn Instruction APPLICATION REQUIREMENTS: This instruction is intended for use with the SL595 Variable Speed operators as a supplemental instruction to the standard SL595 manual, 01-34850. [. . . ] After the limits are set and the gate is operating as intended, the main speed potentiometer can be adjusted as desired. Verify that the gate can run the full open and close distances without incident after adjusting the main speed potentiometer. NOTE: If the gate cannot move at full speed without stopping, the motor profile must be re-learned at a higher minimum speed. To do this, increase the minimum speed by turning the Min Speed Trimpot clockwise. Adjust the Main Speed Potentiometer to its minimum setting (fully counter clockwise) and repeat the motor learn process. MOTOR LEARN FUNCTION (FORCE PROFILE) In order to accurately set the force control for the operator, the control board must "learn" the specific RPM profile for your operator. This is done using the red button, "S3", located at the end of the control board, next to the microprocessor. [. . . ] The yellow LED should start to flash rapidly. Min Speed Trimpot Main Speed Potentiometer 3. [. . . ]