User manual CHAMBERLAIN TM50

[. . . ] To avoid injury, completely lower the shutter before loosening the screws in the tube end of the shutter. Installation and wiring must be in compliance with your local building and electrical codes. Disconnect the power supply to the shutter motor before commencing any repairs A suitable power phase jumper (full-pole disconnect with 3 mm contact opening gap) must be fitted in the power supply. . Any damaged power supply wiring must be replaced by the manufacturer or the manufacturer's customer service agent. [. . . ] This warranty does not affect the purchaser's statutory rights under applicable national legislation in force nor the purchaser's rights against the retailer arising from their sales purchase contract. In the absence of applicable national or EC legislation, this warranty will be the purchaser's sole and exclusive remedy, and neither Chamberlain GmbH nor its affilliates or distributors shall be liable for any incidental or consequential dmages for any express or implied warranty relating to this product. No representative or person is authorized to assume for Chamberlain GmbH any other liability in connection wit the sale of this product. Typ Power Power Supply Torque Pulling Force R. P. M. TM10 125 Watts 230V / 50Hz, cable 2m 10Nm 18kg (40mm Tube) 14 U/Min. TM20 155 Watts 230V / 50Hz, cable 2m 15Nm 25kg (60mm Tube) 18 U/Min. TM30 185 Watts 230V / 50Hz, cable 2m 20Nm 35kg (60mm Tube) 18 U/Min. TM50 235 Watts 230V / 50Hz, cable 2m 40Nm 72kg (60mm Tube) 18 U/Min. INSTALLATION Rough- in or install conduit pipe to the connector box for the electrical connecting line according to local building and electrical codes. B Push the tube adapter (3/4) onto the motor (1), and secure the drive adapter with the fixing parts (2) supplied. Insert the square tube bracket (5) into the recess in the motor head, and apply gentle pressure until it engages. If a square tube pin (5. 1) has been supplied, secure this with the screws. On model TM10, the motor bracket (9) is secured by means of 2 motor bracket mounting screws (10). Remove the manual control (c). J SETTING THE LIMITS Procedure for Adjusting "Open" and "Cose" Positions (refer to figure I for lefthanded installation) #1 Limit Setting for "Shutter Open" + = increase closing travel ­ = decrease closing travel D Remove the tube. E switch operates only if the drive unit is fully inserted. Push the motor (1) completely into the tube. The limit #2 Limit Setting for "Shutter Close" + = increase opening travel ­ = decrease opening travel Ensure that the adapter ring is pushed fully home. F Proceed according to the specific requirements for leftsided (a) or right-sided (b) operation: Secure the mounting bracket (6) to the wall (10) (use G suitable screws and plugs). H Insert the square tube bracket on the motor (1) into the mounting bracket (6) and secure with the cotter pin (7). Make sure the set screws for the limit adjustments (beneath the mounting bracket) are accessible. Don't return the shutter material to the tube yet! Please observe that the limitis of the motor only operate in a complete installation. Read the following instructions carefully before making any open or close limit adjustments. To attach the shutter material on the tube, use ONLY the 3. 9 x 6. 5 mounting screws included (TM20, TM30, TM50). This instruction applies particularly to model TM10 (no screws included). Use the appropriate fixing parts to secure the shutter material to the tube. [. . . ] Have it checked by an authorized electrician and replaced if necessary. · Repeated operation may have tripped the motor overload protector switch. Motor runs intermittently · Have the wiring connection between switch and motor checked by an authorized electrician. [. . . ]