User manual CHAMBERLAIN TCLS2E

[. . . ] We reserve the right to make technical changes in the interests of progress. Stick the TCLS1E on the glass pane at the position the shutter should travel to for desired lighting. In order to test the shading function, push the lower button of the sensor. The shutter will travel downwards until it reaches the level of the sensor. [. . . ] Turn the sensor by one to two degrees if it reacts too sensitively (glass breakage function). During programming the distance between the sensor and timer should be no more than 5 metres. Ensure that you are firmly holding down the two knobs as required as well as simultaneously. Has the timer/receiver been correctly connected and is there a power supply?Don't forget to always confirm your menu selection on the TCTRX2E with the UP key. Declaration of Incorporation The Light and Glass Breakage Sensor Model TCLS1E, when installed and maintained according to all the Manufacturer's instructions in combination with a shutter, which has also been installed and maintained according to all the Manufacturer's instructions, meet the provisions of EU Directive 89/392/EEC and all amendments. I, the undersigned, hereby declare that the equipment specified above and any accessory listed in the manual conforms to the above Directives and Standards. These safety alert symbols mean Caution - a personal safety or property damage instruction. Failure to comply with the following instructions may result in serious personal injury or property damage. Installation and wiring must be in compliance with your local building and electrical codes. Pull the module out of its frame and plug the coupling into the socket on the bottom edge under the TCT2E display. Close the roller shutter manually until the desired shading effect has been achieved. The level of light after which the roller shutters should close (set value), is shown as a small dot in the upper right corner of the bar. Move this dot with the DOWN key to the right end of the black bar and then press the UP key twice. The roller shutter closes and opens again on reaching the set brightness levels with a delay of 15 minutes. Press the suction head onto the inside of the window pane (in case the shading function has not already been adjusted). The sun symbol at the top right of the display now changes into a moon symbol. The level of light after which the roller shutters should close (set value), is shown as a small dot in the lower left corner of the bar. Move this dot with the DOWN key to the right end of the black bar and then press the UP key twice. The roller shutter now closes completely upon reaching the set brightness level. If a fixed closing time has been programmed into the TCT2E and if the set value is reached earlier the roller shutter will also close earlier. If the set value is not reached until after the programmed closing time the shutter will still close at the programmed time. [. . . ] Upon receipt of the product, the first retail purchaser is under obligation to check the product for any visible defects. Conditions: The warranty is strictly limited to the reparation or replacement of the parts of this product which are found to be defective and does not cover the costs or risks of transportation of the defective parts or product. This warranty does not cover non-defect damage caused by unreasonable use (including use not in complete accordance with Chamberlain GmbHs instructions for installation, operation and care; failure to provide necessary maintenance and adjustment; or any adaptations of or alterations to the products), labor charges for dismantling or reinstalling of a repaired or replaced unit or replacement batteries. A product under warranty which is determined to be defective in materials and/or workmanship will be repaired or replaced (at Chamberlain GmbH's option) at no cost to the owner for the repair and/or replacement parts and/or product. [. . . ]