User manual CHAMBERLAIN SCS200

[. . . ] This safety alert symbol means "Caution" - failure to comply with such an instruction involves risk of personal injury or damage to property. This gate drive mechanism is designed and tested to offer appropriately safe service provided it is installed and operated in strict accordance with the following safety rules. Incorrect installation and/or failure to comply with the following instructions may result in serious personal injury or property damage. When using tools and small parts to install or carry out repair work on a gate exercise caution and do not wear rings, watches or loose clothing. [. . . ] If motor was secured using a padlock (optional) instead of the "R" clip, then the lock must be removed using a key. The lock must be shielded against humidity, so it does not freeze in winter. This safety alert symbol means "Caution" - failure to comply with such an instruction involves risk of personal injury or damage to property. This gate drive mechanism is designed and tested to offer appropriately safe service provided it is installed and operated in strict accordance with the following safety rules. Incorrect installation and/or failure to comply with the following instructions may result in serious personal injury or property damage. When using tools and small parts to install or carry out repair work on a gate exercise caution and do not wear rings, watches or loose clothing. Installation and wiring must be in compliance with your local building and electrical installation codes. Any entrapment possibility by the moving wing between wing & walls must be secured with safety edges or IR-sensors. Please remove any locks fitted to the gate in order to prevent damage to the gate. After the installation a final test of the full function of the system and the full function of the safety devices must be done. This drive cannot be used with a gate incorporating a wicket door unless the drive cannot be operated with the wicket door open. Employ a qualified technician to repair the gate, never attempt to repair it yourself. Disconnect electric power to the system before making repairs or removing covers. A disconnecting device must be provided in the permanently-wired installation to guarantee all-pole disconnection by means of a switch (at least 3mm contact gap) or by a separate fuse. Make sure that people who install, maintain or operate the gate drive and/or the control board are qualified and follow these instructions. Attach logic board underneath baseplate; do this using 5 screws and fasten in the box at the marked positions. These might be needed later on individual settings in the controls' programming. (refer to JUMPERS) Put the 4 large closure screws of the box through cover of the box. If the lid does not close completely, then the box is not fitted to the wall evenly and is therefore distorted. A) start with still dead 230Volts supply cable on the left side of the box. Then connect ground wire to base plate with washer and nut (exactly as shown in picture detail). we recommend the following accessories: LA400-JB40E Kit for cable extension of one installation unit. [. . . ] Operate the gate with a remote control or with a connected switch and monitor the direction. If all adjustments are done, check operation of photocells, switch, flashing light, remotes, accessories, etc. Advise people using the gate with regard to gate operation, safety functions and how to release the gate in order to operate it manually. tIMER TO CLOSE NOTE: Only possible with connected photocells (1 + COM). [. . . ]