User manual CHAMBERLAIN RA7524

[. . . ] Neither the manufacturer nor the supplier assumes any liability for personal injury, damage to property or consequential injury or damage occurring as a result of the use of the control units and / or drives for purposes other than those mentioned above or due to changes made to the equipment affecting the safety of the given system. the details stipulated in the Operating Instructions in respect of the operation and repair of the system require strict observance. Neither the manufacturer nor the supplier assumes any liability for personal injury, damage to property or consequential injury or damage occurring as a result of non-compliant actions. [. . . ] FUNCTIONALITY The radio-controlled wall switch is equipped with two buttons one each for UP and DOWN. One button sends a signal for opening the shutter while the other closes it. If the button for the other direction is pressed when the shutter is in motion, the shutter stops. The switch can also be used to operate several drives providing they are within its range (same room). Automatic function: The user can program any set time required for UP or DOWN or for both. PROGRAMMING RADIO REMOTE CONTROLS (HAND-HELD TRANSMITTERS) Please note: In the following text, the radio-controlled wall switch is often described as a remote control because the device concerned is a permanently mounted remote control (wall switch). PROGRAMMING A NEW, ADDITIONAL REMOTE CONTROL (not the first one or so-called master) PLEASE NOTE: The following steps must be executed quickly. The easiest way is for a second person to help by reading out the text while the other person presses the buttons. via the master remote control: Step 2: Press and hold the STOP button. The drive turns 2x briefly as a signal indicating that the command has been understood (approx. Step 3: Then press the UP button (upper button) and also the DOWN button (lower button) immediately and briefly. Once again the drive moves 2x briefly as a signal that the command has been understood. Via the new remote control: Step 4: Press and hold the UP button (upper button) on the new remote control immediately. Once again the drive moves 2x briefly as a signal that the command has been understood. [. . . ] TO OPEN: On the side is a marking identifying the point where a thin screwdriver can be applied to prise open the lid. For more information please refer to the instruction manuals of either the Radio Controlled Shutter Drive or the Retrofit Receiver. CAUTION: When installing this device next to lightswithes or plugs make sure not to damage wiring. [. . . ]