User manual CHAMBERLAIN NTD2

[. . . ] ® Model NTD2 Wireless Portable Indoor/Outdoor Intercom Overview The Intercom has up to a 1000' range and allows multiple simultaneous conversations, using a 900 MHz secure digital radio link. The intercoms form an exclusive network and respond only to other intercoms in the network. Call Mode: In Call Mode the intercom may only be used to call the intercom network and will not be able to hear conversation from within the network. Volume: To increase the intercom volume, place Dipswitch #4 to the UP position. [. . . ] Tighten screws. Mounting with Tape Step 1 Programming Intercom The intercom must be programmed to at least one other intercom to become a network or it can be programmed into an existing network. Create New Network Clean back of intercom and mounting surface using the alcohol wipe. Step 2 Before programming, clear memory on all intercoms. Within 10 seconds put the second intercom into Learn Mode (refer to table below). INTERCOM OR VOLUME MONITOR ACTIVE HOLD OFF LEARN MODE Press the Learn button until a beep is heard. TALK 1 2 3 4 CHANNEL Peel off white paper from mounting tape. Firmly press mounting tape on back of intercom. Each intercom will emit a tone when entering programming mode. It may take up to 3-1/2 minutes for a secure network to be established. Step 3 Add to an Existing Network Peel paper from mounting tape. Firmly press intercom onto mounting surface. Press the Learn button on the new intercom until a beep is heard. Within 10 seconds put any networked intercom into Learn Mode (refer to table below). INTERCOM OR VOLUME MONITOR ACTIVE LEARN MODE Press the Learn button until a beep is heard. HOLD OFF Assemble Intercom TALK 1 2 3 4 CHANNEL Each intercom will emit a tone when entering programming mode. It may take up to 3-1/2 minutes for a secure network to be established. NOTE: Do not program new intercoms to each other before adding them to the network or they will form a separate network and the memory will need to be cleared. Install 4 AA Alkaline batteries (not provided). (Lithium batteries recommended for colder environments. ) 2 Secure Cover Troubleshooting Intercom does not function. Do not mount intercom on a tree, masonry, or metal surface. Secure cover with the two large black screws. Intercom beeps every ten minutes. It may be necessary to clear the network and reprogram all the intercoms to the network. NOTE: Manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. [. . . ] · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. FOR TECHNICAL SUPPORT DIAL OUR TOLL FREE NUMBER: 1-800-528-9131 www. chamberlain-DIY. com NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 114A4097B © 2010, The Chamberlain Group Inc. [. . . ]