User manual CHAMBERLAIN KLIK2U INSTALLATION

[. . . ] The Smart/Learn button or DIP Switches are located on motor unit or external receiver. Clicker products are intended to be used only with garage door openers manufactured after 1993 that utilize photo-eyes safety sensors. [. . . ] If DIP switch is in the "on" or "up" position place a 1, "off" or "down" position place a 2 in the corresponding box in the chart below: NOTE: Leave any unused switch locations blank. Set your first DIP switch to "-", your first DIP switch must be set to the "-" position on your remote and opener. If the DIP switch is in the "+" position place a 1, "0" position place a 2, "-" position place a 3 in the corresponding box in the chart below: NOTE: Leave any unused switch locations blank. 3 = Chamberlain, Sears Craftsman, LiftMaster, Master Mechanic and Do It garage door openers manufactured from 2005 to present [Purple Button]. 5 = Genie Intellicode and Overhead Door garage door openers manufactured from 2005 to present (315 MHz). â· 6 = Genie Intellicode and Overhead Door garage door openers manufactured from 1995 to present (390 MHz). To test and use, wait until light turns off, enter your PIN and press the 0 key. To test and use, wait until lights turn off, enter your PIN and press the 0 key. To test and use, wait until lights turn off, enter your PIN and press the 0 key. If opener does not function, flip DIP switches, so if a switch is "on" or "up" flip it "off" or "down" in step 3. [. . . ] NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [. . . ]