User manual CHAMBERLAIN GWAP120

[. . . ] In order to avoid damage to the shutter installation during initial set up, the shutter strap must be wrapped around the strap spool at least twice when the shutter is open. 2mm Short time rating: max 5min Protection class II (only use in dry areas) Power cable H05 VV-F 2 x 0. Shutter size (shutter size = length x width): Plastic-Mini- Profiles approx. Pull the shutter strap out of the mechanical strap coiler and cut shutter strap approx. [. . . ] Now close the shutter strap coiler back up with the strap spool cover and refasten the screw as shown in fig. Now take the wall plug transformer and put it into the designated opening at the bottom of the appliance (see fig. The shutter strap coiler may only be used in connection with the provided wall plug transformer version 041AGW02. In order to install the light sensor put the plug of the light sensor in the designated opening with the six pins at the bottom of the appliance (see fig. Clean the window pane and position the light sensor onto the window pane as desired. Information: The shutter strap motor will close the shutter after 15min of direct sunlight to the position of the light sensor. In order to open/close shutter again, press corresponding button on the control panel; this may also be achieved by activated timer control. To remove or relocate the light sensor only pull on the small plug (fig. Pulling/Pushing the white plastic top may lead to destruction of light sensor. Make sure that stoppers/conical stops are existent and that these have a firm connection with the shutter. Now push any one of the three buttons of the shutter strap motor (fig. The shutter strap motor will pull the shutter up until the conical stops reach the shutter box (or wall). Then the shutter will be lowered automatically until completely closed and the lower limit is defined. Finally the shutter will be opened again automatically and will stop shortly before reaching upper limit. Should this process be interrupted through power failure or should the plug be pulled accidentally, start over again = push any one of the three buttons. The shutter can be opened or closed by pushing the Open- or Close-button ( fig. Safety function: If obstacle is hit or shutter profiles are tilted the GWAP120 will shut down automatically. Timer Control: In order to program the timer control briefly push (max. Then briefly push Open-/Close-button; the shutter will move to the upper limit and the LED will glow. Then briefly push Open-/Close-button; the shutter will move to the lower limit and the LED will glow. [. . . ] Upon receipt of the product, the first retail purchaser is under obligation to check the product for any visible defects. Conditions: The warranty is strictly limited to the reparation or replacement of the parts of this product which are found to be defective and does not cover the costs or risks of transportation of the defective parts or product. This warranty does not cover non-defect damage caused by unreasonable use (including use not in complete accordance with Chamberlain's instructions for installation, operation and care; failure to provide necessary maintenance and adjustment; or any adaptations of or alterations to the products), labor charges for dismantling or reinstalling of a repaired or replaced unit or replacement batteries. A product under warranty which is determined to be defective in materials and/or workmanship will be repaired or replaced (at Chamberlain's option) at no cost to the owner for the repair and/or replacement parts and/or product. [. . . ]