User manual CHAMBERLAIN CWPIR INSTALLATION

[. . . ] ® Model CWPIR Wireless Motion Alert Sensor Overview The Wireless Alert Sensor is a Passive Infra-Red (PIR) sensor that detects movement of people and vehicles, while allowing small animals to pass through undetected. The base station (not provided) can learn the signals of up to 4 sensors. [. . . ] Buzzer will sound. B Insert battery pack facing away from circuit board and attach cover. NOTE: Ensure the batteries do not touch the circuit board and the antenna and battery wires are not pinched. B Within 5 seconds, wave hand in front of PIR Motion Sensor. Test light will illuminate and Base Station will buzz. PIR Motion Sensor Installation Step 6 Step 4 Mount PIR Motion Sensor horizontally on solid surface a few feet off the ground and within 900' of Base Station (rotate sensor to access screw holes). Do not mount PIR Motion Sensor in direct sunlight, near moving tree branches, or in the path of a sprinkler system. 2 Vehicle Alert Installation: For cars, the best mounting position is about 4' high, between 10-20' back, and angled to see the back of car after passing the sensor. 10' - 20' 3' - 5' Troubleshooting The PIR Motion Sensor lights up, but the Base Station does not respond. The PIR Motion Sensor must be programmed to Base Station (See Step 5). If the green power light is not lit or is flashing, press the Mute Button on the top of the Base Station to wake it up. If the green power is illuminated, look at the two small white Base Station switches next to the Learn Button. If the Base Station signals when you press the Learn Button, it is not muted. To detect cars, it is best to mount PIR Motion Sensor at height of car's motor and have it between ten and twenty feet from the road. [. . . ] Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment. 3 FOR TECHNICAL SUPPORT DIAL OUR TOLL FREE NUMBER: 1-800-528-9131 www. chamberlain-DIY. com NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 114A3897 © 2008, The Chamberlain Group Inc. [. . . ]