User manual CHAMBERLAIN 945CB

[. . . ] ® WARNING FOR USE WITH GARAGE DOOR OPENERS MANUFACTURED AFTER JANUARY 1, 1995. To ensure proper functioning of your opener, remove all old or previous push buttons/wall control panels. [. . . ] Fasten with 6ABx1-1/4" self-tapping screws (standard installation) or 6-32x1" machine screws (pre-wired installation) as follows: · (Standard Installation ONLY) Drill pilot holes and install bottom screw, allowing 1/8" (3 mm) to protrude above the wall surface. · Position bottom of door control on screw head and slide down to secure. (Standard Installations ONLY) Run bell wire up wall and across ceiling to motor unit. Use insulated staples to secure wire to wall and ceiling in several places. Do NOT pierce wire with a staple, this will create a short or open circuit. Connect bell wire to terminals as follows: · Quick Connect Terminals: Red/white wire to red terminal and white wire to white (Figure 1). Replace the cover by inserting the bottom tabs and snapping it into place. Press again to reverse the door during the closing cycle, or to stop the door while it is opening. Light Feature: Press the Light button to switch the opener light on or off. When the door is opened or closed, the light will remain on for 4-1/2 minutes. The Light button will not control the opener light when the door is in motion. Lock Feature: Designed to prevent operation of the door from portable remote controls. [. . . ] · Activate door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel. NEVER permit anyone to cross path of closing garage door. Figure 1 Push Button Terminal Screws RED WHT Quick-Connect Terminals Bell Wire LOCK LIGHT Light Button Lock Button Door Control Connections Strip wire 7/16" (11 mm) 7/16" (11 mm) To release wire, push in tab with screwdriver tip Antenna Red White Grey OR Figure 2 Opener Terminal Screws Push Button Terminal Screws RED WHT Bell Wire LOCK LIGHT Lock Button Light Button Opener Panel Antenna 114A2381D © 2006, The Chamberlain Group, Inc. [. . . ]