User manual CHAMBERLAIN 600152

[. . . ] Any control board with a normal close release function (NO) is able to operate with the signal now. [. . . ] The size of some doors is the factor which determines which profile size/height is required. Use a special tool for cutting PVC pipe or rubber hoses, a pair of pliers, a fine cutting saw or a sharp knife may also be used. When using the closing cap with sealing lip, the cut must be 12 mm away from the profile's base. The cut must be made carefully to ensure that the profile base is completely trimmed off, leaving a flush surface. When making a cable connection, select the required cable exit and remove the plug from the grommet with a hole punch or screwdriver. Then apply cyanacrylate adhesive evenly on the roughened surface of the profile and immediately place the closing cap carefully on the profile and apply pressure for about 10 sec. [. . . ] To ensure complete seal, apply Cyanacrylat adhesive on the Contact Duo-Profile around the grommet. [. . . ]