User manual CHAMBERLAIN 50-1950 INSTALLATION

[. . . ] Assemble post bracket assembly by placing push-to-open bracket between the two post brackets as shown. [. . . ] Mount gate bracket to actuator side of operator with pin and hairpin clips (Figure 3). Figure 1 3/8" Hex Bolt Post Bracket Push-to-Open Bracket Post Bracket 3/8" Flat Washer 3/8" Lock Washer 3/8" Nut Figure 2 Center of Gate Hinge 5/16" Hex Bolt 7-3/4" 90° 7-3/4" Special Post Pivot Bracket for Push-to-Open Installation Pin Hex Bolt Post Bracket Figure 3 Push-to-Open Bracket Flat Washer Lock Washer Pin Nut Hairpin Clip Gate Bracket Hairpin Clip 7. With gate open and operator in retracted position, clamp bracket to cross member, using C clamp. Once brackets are clamped in place, remove clevis pins and washers to detach operator. Be sure to mark holes in the vertical center of post bracket slots (Figure 5). Drill 13/32" holes in marked locations for gate post and 11/32" for gate bracket. Secure post bracket assembly to gate post with 3/8"-16 x 6" carriage bolts, flat washers, lock washers and nuts. [. . . ] Reconnect power to operator. Batteries Control Board and Mounting Plate 01-32479B © 2008, The Chamberlain Group, Inc. [. . . ]