User manual CELESTRON POWERSEEKER 80 Quick Setup

[. . . ] CONTACT: Celestron Technical Support: 310. 803. 5955 Item# 21048 Quick Set-up Guide 2 3 1 Your PowerSeeker 80 includes: optical tube w/ tube rings & lens shade attached; tripod with center support bracket; equatorial mount; two eyepieces; a 3x barlow lens, finderscope; 5 lb. [. . . ] Thread the tray into the threaded hole in the center of the leg brace. Properly assembled, the accessory tray should appear as pictured above. 7 8 9 Locate the equatorial mount and place the base of the mount through the hole in the center of the tripod mounting platform. From underneath the tripod mounting platform, thread the mounting bolt with washer into the threaded hole on the bottom of the equatorial mount. Thread the latitude adjustment screw into the equatorial mount until it is touching the inside of the mount. Quick Set-up Guide [cont] 10 11 12 Locate the counterweight bar and counterweight. Slide the counterweight half way down the counterweight bar and tighten the locking screw to secure in place. Thread the threaded end of the counterweight bar into the Dec axis of the equatorial mount. Slide the chrome end of the slow motion control cables onto equatorial mount gear shaft and tighten set screw to secure in place. 13 14 15 The longer cable should attach to the Right Ascension axis and the shorter cable attaches to the Declination axis as shown above. Before mounting the tube, remove the two wingnuts on the tub rings. Place the tube on the mount by lining up the screws with the mouting holes on the mount. The dec cable should be extending towards the focuser end of the telescope tube. 16 17 18 Reattach both wingnuts and tighten to secure in place. Loosen the set screw on the focuser so that it does not obstruct the inner diameter of the focuser. Remove plastic cap. Insert the chrome barrel of the 20mm eyepiece into the focuser and tighten the set screw. 19 20 21 Locate the finderscope. Remove the knurled nuts on the threaded posts at the focuser end of the telescope tube. Orient the finderscope so that the large lens is facing towards the front of the tube. Place finderscope over the posts on the tube and tighten it down with the knurled nuts. Remove the lens cap from the front of the telescope. [. . . ] Place the barlow in the focuser in place of the eyepiece - remove the cap from the barlow. Place the eyepiece into the barlow and tighten the set screw to secure in place. For detailed usage information please consult your owner's manual. [. . . ]