User manual CATA CMD7109X

[. . . ] This appliance can be used by children aged from 8 Years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Cleaning and user maintenance shall not be made by children without supervision. Do not put heavy weights on the oven door and make sure that children do not climb or sit on it. After using the oven, make sure that all the controls are in the off position. [. . . ] The time will automatically be confirmed after 10 seconds, or if you press the dial (2. Note: the time will need to be set again after an electricity cut or when the hour changes. Consult the cooking table to choose the accessory or accessories to be used and their position. Select the cooking function according to the model Traditional fanned heat. Several dishes may be cooked at once without their flavours or smells mixing. (*) This is the function used in the declaration of energy consumption, in accordance with regulations R65-R66/2014, according to rule 60350-1. The pilot light will switch off when the selected temperature is reached. If you prefer the oven to function without a time limit, turn it to hand position . The time will automatically be confirmed after a few seconds and the countdown will start. Cooking with the start timing function allows you to start and finish cooking automatically according to the programmed time. To programme the cooking start time, briefly Press the dial once until the To increase or decrease the cooking start time Turn the dial to the left or right. The icon will continue to flash for several seconds after the last turn. If, during this time the dial is not pressed or turned, the hands of the clock automatically turn to show the time and the programme is cancelled. Confirm the cooking start time ( icon is on) And the timer changes to (the starts to flash again). To programme the cooking end time, follow the same procedure as described above. Digital clock (e): Select the cooking function, the temperature and the cooking time. The cooking start time will be delayed so that cooking finishes at the time shown. 3): Cooking by programming the cooking end time allows you to immediately start cooking and stop cooking automatically at the programmed time. To programme the cooking end time, briefly Press the dial twice until the icon flashes. The icon will continue to flash for several Seconds after the last turn. If, during this time the dial is not pressed or turned, the hands of the clock automatically turn to display the time and the programme is cancelled. Press the dial to confirm the cooking end time (minimum cooking time, 2 minutes). [. . . ] At the end of the cycle, remove the water from inside and wipe away any remaining dirt with a dishcloth. This cycle is used to assist cleaning but loses its effectiveness if the recommended times are not followed. this Is normal, as the fan keeps running until the temperature inside and outside the oven is reduced. Digital display models have a diagnosis system which detects any problems and warns the user. [. . . ]