User manual CAT EYE TRIPLE SHOT

[. . . ] CAUTION!: Pay attention to the arrangement of the cable so that it does not interfere with the handling of the bicycle. Do not secure the cable at an acute angle because the wire inside the cable may break. Line To Battery Unit Lock To Battery Unit COMPONENTS Frame or Stem H31 for oversized handlebars H32 Cable Straps (x 2) Cable Support Strap Cable Straps Cable Straps Light Unit/Switch Unit Battery Unit/Battery Bag Battery Charger Bracket (with thick and thin rubber pads for each) FOR SAFE OPERATION · Never short-circuit the terminals of the battery unit or the battery charger. It may cause the unit to overheat, resulting in fire or damage to the component. [. . . ] 3. 3 hours Button Beam Adjustment Bracket Loosen the lever Quick lever How to Charge Battery Unit Important! Charging indicator state Before Initial Use The battery is shipped with a small charge, that is used to test the unit at the factory. (Refer to the "How to Charge" section in this manual. ) HOW TO MOUNT Installing Bracket Attach bracket H31 or H32 to the handlebar. 2 thicknesses of rubber pads are supplied; if necessary, cut the rubber pad to fit. CAUTION!: Be sure to adjust the angle of the light's beam by referring to the "How to Adjust Beam Angle" section in this manual before operating the lighting system. Orange Light : Connected to power source · Be sure to use only the supplied battery charger. Green Light : Charging is completed · Do not completely remove the battery unit from the battery bag. · After charging, return the battery to its original storage state. · The standard charging time and run time are guideline values and depend on the operating environment. · If the battery unit repeatedly does not meet the proper run time even though it is fully charged, it might be at the end of its operating life. The used battery unit should be disposed of properly according to local regulations. Bracket Rubber pad Quick lever (For H32 only) Handlebar or 1. NOTE: When charging is complete, the indicator light changes from flashing red to green. Refer to the figures below to rearrange the cable and use the seal strap to tightly close the opening. CAUTION!: When securing the battery to the frame, make sure the fixing strap attaches to the center of the battery unit. Charging Indicator To AC Power Outlet Battery Charger Battery Unit After Charging Cable Arrangement Mounting Light Unit/Switch Unit Mounting Light Unit Mount the light unit onto the bracket. To remove unit after use, pull it out while pressing the button on the bracket. CAUTION!: Make sure the light unit is cool to the touch before removing it. Light Unit Charging jack Seal Strap Button Slide in Standard charging time Plug Approx. 3 hours Charging jack Fixing Strap How to Store Battery Unit Switch Unit Strap Battery Unit Mounting Switch Unit Mount the switch unit onto the handlebar. CAUTION!: Mount the switch unit where it does not interfere with the handling of the bicycle. Adjust the length of the strap with the toggle and wrap the strap under the bar, hooking it on the switch unit. Make sure the switch unit does not move around easily. The battery unit is stored in its bag as shown in the figure. [. . . ] 3 hours Temperature range ------ Charging: -10°C - 40°C Operating: -15°C - 45°C Recharge/discharge number of times About 300 times (until the rated capacity drops to 50%) * The specifications and design are subject to change without notice. LIMITED WARRANTY If trouble or damage occurs during normal use, the product will be repaired or replaced free of charge. Type your name, address, date of purchase and the situation of trouble clearly on the warranty certificate, and send it back to the appropriate service center together with the product. Insurance, handling and transportation charges shall be borne by the customer. [. . . ]