User manual CAT EYE TM1600E

[. . . ] Connect the newly mounted circuit board with the adjoining circuit board, using the connector cable provided in the kit as shown in Fig. 4. To assure positive connection, insert the cable terminal until a click sound is heard. Carefully close the upper and lower bodies and fasten the 8 screws securely. Place the thermal paper in position, and mount the control unit on your Ergociser following the EC-1600/3700 operating instructions. Screws Circuit board Upper body Guide stubs Fig. 3 Connector cable Introduction We thank you very much for your purchasing "Chest Belt Heart Rate Sensor Kit" for use with our ErgociserTM. [. . . ] Place the circuit board in position to the right lower corner of the upper body, in such a way that the cover guide stubs meet the mating holes provided on the board, and set it securely with 2 screws provided in the kit. (Fig. 7) IMPORTANT: Be careful about the direction of the circuit board. Connect the newly mounted circuit board with the adjoining circuit board, using the connector cable provided in the kit as shown in Fig. 8. To assure positive connection, insert the cable terminal unit a click sound is heard. guide stubs Fig. 7 connector cable screws Lower body 5. Fix the bottom cover of the unit with 10 screws and assemble the unit. Upper body Fig. 8 6. Mount the control unit on your Ergociser following the EC-5000 operating instructions. Fig. 2 2 Replacing electrode belt WEARING HEART RATE SENSOR Before wearing chest belt heart rate sensor · Wear the chest belt heart rate sensor at the center of your chest and in contact with your skin. · To increase measurement effectiveness, dampen the electrode area with water or electrocardiograph electrolyte cream. · People with sensitive skin can wear the chest belt over a thin shirt with the electrode area damped with water. · Hair on the chest may interfere with accurate measurements. The electrodes on the chest belt naturally wear out after extended use. When there are cracks on the surface or measurement error occurs, replace the electrode belt with new one according to the following instruction: Screws 1. (Fig. 15) Spacer Wearing the chest belt heart rate sensor IMPORTANT: When wearing the chest belt heart rate sensor, ensure that the top mark on the transmitter comes to the top. If worn upside down, signal's transmittable distance might become shorter. (Fig. 16) IMPORTANT: If the contacts are dirty, the electrodes may fail to detect heart rate. Fig. 15 Attachment belt Transmitter Electrode belt 4. Put the spacers back and fasten the screws securely. Contact Fig. 16 2. (Fig. 10) REFERENCE: When wearing the chest belt heart rate sensor over a shirt it is necessary to moisten the electrode area for the better results. In the winter season when skin can be dried, errors may occur even when the electrodes are in direct contact with your skin. (Fig. 11) Fig. 9 Hook NOTE: When replacing the electrode belt, also check the transmitter's battery life. Handling care · Avoid dropping or severely jarring the chest strap. · Avoid using this unit in dense electromagnetic field, such as near TV or radio set, etc. Fig. 10 · Try to avoid using the main unit within a 1. 5m radius of other transmitters. · Do not use the chest belt if it causes a rash or other skin irritations. · When the chest belt becomes soiled with sweat, clean it with mild soap and water. [. . . ] NOTE: The chest belt heart rate sensor continues to consume battery while being attached to your body. When you are not measuring heart rate, remove it from your chest to save the battery life. Replace the old battery with a new lithium battery (CR2032) with the (+) pole upward as illustrated. Close the battery cover securely. Battery cover Water proof packing If the above remedy doesn't help, also check if the circuit boards are positively connected. Chest belt heart rate sensor specifications Maximum transmitting distance: about 70 cm Operating temperature: 32°F-104°F (0°C - 40°C) Battery life: abt. [. . . ]