User manual CAT EYE HL-MH310 (STADIUM 3)

[. . . ] To remove the battery, turn the bottom part of the bottle battery counterclockwise. · Although the lamp body and the battery are water-resistant (under normal weather conditions of rain, etc. ), never intentionally submerge them under water. The light output will remain high until the batteries run out, and will drop suddenly. Always pay attention to the remains of the charge and take precautions by preparing a spare light. [. . . ] (For a more secure fit, use a screwdriver. ) Mounting Lamp Unit slide bracket lever Warning !!!· To mount the lamp body, slide it backward onto the bracket until it clicks into position. · To remove the lamp body, slide it forward while pushing the lever. Mounting Ballast bottle cage ballast Attach the ballast under the top tube and round the belt. If it is not secure, use the supporter and stopper as shown in the figure. If your frame is Y-frame, attach the ballast at the side of the frame. Note !: Be sure that the ballast is tightly attached to the frame. Installing Bottle Battery stopper bottle battery Insert the bottle battery into your bottle cage. Note !: The bottle battery might jump out of the bottle cage during ride. Be sure that it is tightly and firmly fixed. Connecting Cord supporter Connect the jack of the bottle battery's cord and the plug of the ballast's cord. Note: Securely connect the jack to the plug. HOW TO USE The continuous run-time is 3 hours from the fully-charged condition. Note !: When the temperature is very high or low (even within the operating temperature range), the operation time might become shorter than the standard time due to the characteristics of the battery. · After switched on, it takes about 30 seconds for the light to reach its full brightness. · Because of the characteristics of the bulb, the beam may flicker or discolor during operation due to change of the temperature or fluctuation of voltage. Note !: In case the light does not turn on, switch it off once and wait for more than 15 seconds; then try again. After switching off, wait more than 15 seconds until switching on again. Note !: If the light does not turn on although you have tried several times, charge the battery. Note !: In case there are frequent failure when switching on, the bulb needs to be replaced. Power Indicator The light goes off in about 10 minutes after the RED power indicator turns on. Stadium Light 3 battery belt run-time is 3hours switch power indicator E battery cap HOW TO CHARGE Use only the included AC adapter with an AC outlet. [. . . ] For the information of the products, please also see CAT EYE website. LIMITED WARRANTY 2-Year Warranty: Only Lamp Unit, Ballast and AC Adapter (Excluding bulb and battery) If trouble or damage occurs during normal use, the product will be repaired or replaced free of charge. Type your name, address, date of purchase and the situation of trouble clearly, and send it back to the appropriate service center together with the product. Insurance, handling and transportation charges shall be borne by the customer. After being repaired or replaced, the product will be shipped back to the customer. [. . . ]