User manual CAT EYE CC-ST200

[. . . ] * When current speed does not appear, short-circuit the contact on the back with metal. ----- Is there anything on the contact of the main unit or of the bracket?----- Are the marking line of the sensor and the center of magnet matched each other?----- Refer to "Sensor/Magnet Mounting" and re-adjust correctly. [. . . ] 115 Boulder, CO 80302 Phone: 303-443-4595 Toll Free: 800-5CATEYE Fax: 303-473-0006 e-mail: CatEyeUSA@aol. com #166-5120 Wheel Magnet #169-6180 Lithium Battery (CR1620) E OPERATING INSTRUCTIONS A. Main Display (Speed) Sensor Pulse Symbol Mode Symbol Speed Scale Symbol Auto Mode Symbol Sub-Display (Selected Function) M (Mode) Button H. Sensor Band Screw Sensor Bands-A (S)(L) Sensor Bands-B Magnet Sensor Band Rubber Pad CA T EY E MOUNTING TO BIKE · The spokes must run correctly through the inside the magnet as in fig. 8. Choose a band that fits the fork diameter (S size for up to 24ø, L for oversize). Insert the band-B into the slit of the band-A, and put the rubber pad inside of the band-A(fig. Adjust the length in order that the screw-fastening part of the bands are parallel when mounted to the fork(fig. Mount the adjusted bands to the fork along with the sensor, by temporarily tightening the screw(fig. Align the magnet's center and the sensor's marking line(fig. 12), and make sure of 2mm clearance between the magnet and sensor (fig. Loosen the wire in the area marked with the arrow so that the wire does not hinder handlebar operation. · Use either 1mm- or 2 mm-thick pads if necessary, according to handlebar diameter. · Slide main unit onto the bracket from front until it clicks into position. 16) MAIN UNIT PREPARATION The following must be completed before operating. (1) How to measure wheel circumference (L) of your bike (Fig. 4) Put a mark on the tire tread and ride the bike one full wheel revolution. Mark the start and the end of the revolution on the ground and then measure the distance between the two marks. Or, the "Selecting Values Cross Reference Table" tells you an approximate circumference according to tire size. L Fig. 4 (2) Setting Speed Scale Preform all clear operation. Km/h and mile/h are alternately displayed with each press of S/S button. 6. Fig. 5 (3) Setting the wheel circumference (Fig. 6) The standard wheel circumference of 216 cm for 27" wheel is displayed. ODO will be displayed, and the desired number is set. ·Test (Fig. 16) Mount main unit. If main display does not show any figures, press either M button or S/S button to release from power saving function. [. . . ] When pressed in stop state in each mode, the following can be revised. · In ODO mode --------------------- Wheel circumference · In mode ----------------------- 12-hour clock · In TM, DST or AVS mode ----- On/off the Auto function AUTO (AUTOMATIC START/STOP) FUNCTION DST AUTO Reset Operation: (Fig. 2) Select any mode except ODO, then press M button and S/S button simultaneously. (When done in ODO, registered wheel circumference will be displayed. ) RESET All Clear Operation: (Fig. 3) When M button, S/S and set buttons are pressed simultaneously, all data stored (ODO, speed scale, Wheel circumference and clock time) is erased. This should only be executed after replacing battery or when irregular display occurs due to static electricity, etc. [. . . ]