User manual CAT EYE CC-CL200

[. . . ] This button should be pressed only after replacing the battery or when irregular display of information occurs due to static electricity, etc. Once this button is pressed and all memory is erased, it will be necessary to set the wheel circumference, time, etc. (refer to Main Unit Preparation) Fig. 5 B Fig. 6 Reset Operation: (Fig. 2) A AT Press left button to select any mode except total distance (O) and press left and right buttons together. Stored data of trip distance (D), elapsed time (T), average speed (A) and maximum speed (M) are all reset to zero. [. . . ] (Refer to the explanation of Auto Mode function. ) While keeping the right button pressed , press the SET button. The first wheel circumference measurement will be displayed for a few seconds, then the second setting will appear. #169-6690 Parts Kit #169-6660 Bracket Kit sensor band B sensor rubber pad sensor band A Fig. 12 sensor band B sensor rubber pad 5. How to reset the Wheel Circumference Select the (O) mode and stop the measurement. Press SET button and the already set wheel circumference will blink on the sub-display. Refer to '3. Setting the wheel circumference' to complete the setting. Setting the 24-hour Clock (Fig. 8) Press left button for more than 2 seconds to select the 24-hour clock display. Press right button to select a minute time sensor band A ahead of the current time by 1 to 2 minutes. Fig. 13 #169-6670 Cordless Sensor #169-6680 Universal Sensor Band screw sensor Fig. 14 spacer front fork MOUNTING TO BIKE If necessary, use either the 1mm or 2mm thick rubber pads according to the handlebar diameter. · Slide the main unit onto the bracket from front until it clicks into position. To remove the main unit, pull it forward while depressing the lever on bracket (fig. 10). How to Mount the Sensor on the Right Front Fork Leg. (fig. 11) #169-6667 Center Mount Bracket Kit #169-6669 Stem Mount Bracket Kit Mount the sensor in the highest possible position on the right front fork leg. Adjust the position, clearance and direction as follows: (1) Insert the band B into the slit of the band A, and put the rubber pad inside of the band A (fig. Adjust the length of the bands in order that the screw-fastening part of the bands is parallel when mounted to the fork (fig. long screw (2) Mount the adjusted bands to fork along with the sensor, by temporarily Fig. 15 tightening the screw (fig. 14). If the space between front fork and spoke of your bike is big, use the spacer and long screw as in the fig. 15, so that the clearance between sensor and magnet will be approx. (3) Use a coin to install the magnet securely to the spoke so that it face the sensor zone. (fig. 16 & 17) magnet (4) A 5mm clearance shall be kept between the sensor and magnet(fig. 18). Meanwhile, the sensor shall aim at the main unit indicated by the triangle marked on the sensor. Cut the excess sensor zone Fig. 16 sensor band B with scissors or the like. SENSOR with TRANSMITTER SENS OR ZONE magnet Check points for sensor mounting: 1. The triangle mark on the sensor shall aim at the main unit. #169-6070 Wheel Magnet #166-5150 Lithium Battery (CR2032) Fig. 17 spoke COIN TEST Mount the main unit on the bracket. If current speed doesn't appear on the sensor zone main display, press either left or right button to release the unit from the power about 5mm saving mode. [. . . ] Figures do not appear on the main display ------------- Cancel the power saving function. Speed is not displayed when riding with high speed or at low temperature. --------------------------------------------------------------------- Check the sensor position and direction. --------------------------------------------------------------------- Has the battery worn out? [. . . ]