User manual CASTLE DL4600

[. . . ] For product consultancy and technical support, please contact your local sales representative. Com II FCC Regulations This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Settings > Key Click The system will produce an audible signal when any key on the keypad is pressed. To disable a previous password, enter blank on the "Input new password" and "Verify password" screens. If a multi-language font file is downloaded, you will be able to select a font from the list. Settings > Reset to Default Reset system settings to the default values, except for the reader settings. Note: The supported symbologies depend on the scan engine you use, and some of them are not enabled by default. Tests > Buzzer Test the buzzer with different frequency/duration combinations. Press any key and its corresponding character will be shown on the screen. Chapter 4 Configuration 31 Tests > Memory Test the data memory (SRAM), and the results will be shown on the screen. Tests > Echo Test After a physical connection is established properly, run the utility “Echo Test” on your computer and start this test on your mobile computer. IR (Cradle-IR): This echo test is to verify connectivity via IR between the mobile computer and any cradle. Note: For the Modem Cradle, any value other than 57600 bps (default) must be configured through the DIP switch on the IR control board. Chapter 4 Configuration 41 IR Network Menu > Echo Tests The Ethernet Cradle supports three working modes: Data Mode Modem Mode Transparent Mode These echo tests are used for verifying connectivity via the Ethernet Cradle. Server Mode - Set the mobile computer as a server that waits for other devices to connect to. Note: After the “Ethernet via IR” connection is established properly, run the utility “Echo Test” on your computer (TCP/IP – Server or Client), and then, start this test on your mobile computer. 7 (3) Bluetooth Menu – for 8061 This submenu is for the Bluetooth module to work with other Bluetooth enabled devices. Note: This submenu is generated only when the Bluetooth module is present. Information LIB MAC ID C library version for Bluetooth (BNEP) MAC ID of the Bluetooth module A name given to the mobile computer for identification. Local Name) CTY "Normal" means all 79 channels are available for frequency-hopping (There are bandwidth limitations for 2. For example, only 23 RF channels are defined instead of 79 RF channels in Japan, Spain and France. ) DHCP IP Mask Gate DHCP server in use or not IP address of the mobile computer Subnet Mask Default Gateway 44 8000 Series Reference Manual Bluetooth Menu > Connect Setting A basic Bluetooth system can be configured as (1) point to point - DUN mode, and (2) point to multi-point - SPP or PAN mode. Otherwise, the mobile computer will fail to make a connection with any device without pairing. DO NOT specify any remote name when roaming across different groups of APs is required. [. . . ] Regarding the reader Perform the reader test to see if the reader is working. 3) If the problem persists, slide the battery latch to reload the battery pack. 74 8000 Series Reference Manual The reader does not decode after scanning… Unreadable barcode Check if the barcode is defaced. Un-programmed to read Check if the scanner is programmed to read the symbologies (types of barcode) that you are trying to read. [. . . ]