User manual CASIO HZ-600

[. . . ] Never place heavy objects on the power cord, and never expose it to direct heat. · Use only the AC adaptor specified for this unit (optional AD-A95100). Use of another AC adaptor creates the danger of fire and electrical shock. · Should the power cord become seriously damaged (internal wiring is exposed or cut), request servicing from your original dealer. [. . . ] · The following are the tape widths that can be used with this printer: 6mm, 9mm, 12mm, 18mm. To load a tape cartridge 1. · If there is a cartridge already in the Label Printer, remove it by grasping the cartridge on both sides with your thumb and forefinger, and lift straight up. Remove the stopper from a new tape cartridge and check to see that the tape is ready to use. 4. Use a pencil or some other thin object to take up slack in the ink ribbon as shown in the illustration. · If the ink ribbon is slack when you load it into the Label Printer, it can break or cause some other problem. · Be sure to turn the ink ribbon take up spool only in the direction indicated by the arrow (a). · Turn the spool until the other spool (b) starts turning in the direction noted by the arrow. Load the tape cartridge into the Label Printer, making sure that the tape and ink ribbon pass between the head and roller. Close the back cover. (a) (b) Roller Head · Make sure that the tape is under the tape guide and that it is not bent or twisted. Tape guide 7. Turn on Label Printer power and press FUNCTION and then PRINT (FEED) two or three times to make sure that the tape comes out without any problem. · If the tape does not come out normally, turn off power and start again from step 1 above. OK! Tape Width Specification Important!You can select between shading, underline, and box. Display Symbols and Indicators Before getting into actual input, you should first become acquainted with the symbols and indicators used on the Label Printer display. Function indicator Effect indicators Style indicators Stamp printing indicator Mirror image printing indicator STAMP MIRROR M-FEED 6mm AAAAAA A Shift indicator Code indicator FUNCTION SHIFT CODE CAPS CAS Cursor Character position marks Manual feed indicator Caps indicator 6mm tape indicator · Style indicators These indicators point to the character style that is currently in use. · Stamp printing indicator This indicator appears when the Label Printer is set up for stamp printing. Labels you create with stamp printing can be attached to an optionally available stamp holder and then used as a pre-inked stamp. · Mirror image printing indicator This indicator appears when the Label Printer is set up for mirror image printing. Normal (non mirror image) printing is performed when this indicator is not shown. E-9 · Function indicator This indicator appears when you press the FUNCTION key. Pressing a key while this indicator is on the display causes the function marked above that key to be executed. · Manual feed indicator This indicator appears when you are using manual feed instead of auto feed. · After you finish printing when using manual feed, be sure to always press FUNCTION and then PRINT (FEED) to feed the tape before cutting it. · 6mm tape indicator This indicator appears when you use the procedure on page 8 to specify you are using 6mm tape. No indicator is shown when you are using other (9mm, 12mm, 18mm) tape. Any character you input appears at the point where the cursor is located. [. . . ] Cut off excess tape with scissors, and carefully replace the cartridge into the label printer. Never allow the tape outlet to become blocked and never touch tape as it is being fed during printing. Action Input the text you want to print. , CANCEL NORMAL NO OFF STR?3 OFF Troubleshooting · Power Supply Nothing appears on the display. [. . . ]