User manual CARRIER 50QKAUTR

[. . . ] -- General: We advise you to epilate in the evening, as skin irritation usually disappears overnight. 6 English -- General: Epilation is easier and more comfortable when the hairs have a length of 3-4 mm. If the hairs are longer, we recommend that you shave first and epilate the shorter regrowing hairs after 1 or 2 weeks. Epilating the legs with the epilator -- If you already have some experience with epilation, you can simply use the epilating head with the basic epilation cap. [. . . ] Note:When you use shaving foam or gel, clean the shaving head during and after each use with water to ensure optimum performance. 8 When you have finished shaving, switch off the appliance and clean the shaving head according to the instructions in chapter ‘Cleaning and maintenance’. 9 Put the trimming comb on the shaving head when you store the appliance. Trimming with the comb Use the shaving head with the comb attached to trim your hairs in the bikini line to a length of 3 mm. You can also use the comb to pretrim long hairs (longer than 10 mm) on the underarms or legs. 1 Press the release button (1) and remove the epilating head from the epilator (2). 2 Put the shaving head on the appliance and press it until it snaps home. Note:To avoid overheating of the appliance, do not press it too hard onto your skin. The appliance works best when you move it over your skin without excessive pressure. If the overheat protection is activated, the appliance switches off automatically and the charging light and the speed lights flash red for 30 seconds. You can deactivate the overheat protection by letting the appliance cool down and then switch it on again. Do not point the light of the Smart Tweezers directly at your or somebody else’s eyes. Replacing the batteries 1 Open the battery and light compartment by turning the bottom anticlockwise with a coin. English 3 Insert the new button batteries with the negative side pointing forward into the battery and light compartment. 13 Note:The Smart Tweezers work on three alkaline button batteries, type L736H or AG3 (dia. 4 Screw the bottom back onto the battery and light compartment by turning it clockwise with a coin. Cleaning and maintenance Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. If necessary, clean the adapter with the cleaning brush or a dry cloth. Cleaning the epilator and attachments Clean the epilating head after each wet use to ensure optimum performance. 3 Press the release button (1) and remove the epilating head from the appliance (2). Note: Never try to detach the epilating discs from the epilating head. 5 Rinse all parts (epilator, epilating head and caps) under a lukewarm tap while turning them. [. . . ] 2 Remove the epilating head and open the appliance with a screwdriver. 3 Insert the screwdriver into the small slot in the printed circuit board (1). Turn around the screwdriver until the connection between the printed board and the batteries breaks off (2). Do not try to reassemble the appliance in order to connect it to the mains. [. . . ]