User manual CARLSBRO TUFF-TONE

[. . . ] •• Ensure that you always have easy access to the power cord, plug, or adaptor to disconnect this device from the power. flames or heat. Mains fuse This information applies only to products with a UK mains plug. If you replace the fuse, use one with: • the ratings shown on the plug, • a BS 1362 approval, and • the ASTA approval mark. Contact your dealer if you are not sure about what type of fuse to use. [. . . ] n • Stop play or erase a program. q p o n m l k j f g h i VOL SHUFFLE MUTE DISPLAY PROG TIMER SOUND CLOCK SLEEP a • Turn the unit on or off. • switch to standby mode or Eco power standby mode. o REPEAT • Play a track or all tracks repeatedly. p • Start, pause, or resume play. b CD • Select CD source. Adjust time. q USB/AUDIO IN • Select USB or AUDIO IN source. r • Press to open or close the disc compartment. 6 EN 3 Get started Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Connect power Caution voltage corresponds to the voltage printed on the back or the underside of the unit. When you unplug the AC power cord, always pull the plug from the socket. •• Before you connect the AC power cord, ensure that you have completed all other connections. •• Risk of product damage!Ensure that the power supply Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. ___________________________ FM SPEAKER OUT (8 ) ANTENNA Connect speakers Note •• For optimal sound, use the supplied speakers only. •• Connect only speakers with impedance that is the 100-240 V~50/60 Hz AC MAINS~ same or higher than the supplied speakers. / to select a preset In tuner mode, press and hold PROG for three seconds to activate automatic programming. »» All available stations are programmed in the order of waveband reception strength. »» The first programmed radio station is broadcast automatically. EN 11 6 Other features Set the alarm timer This unit can be used as an alarm clock. You can select CD, FM, or USB as alarm source. Note •• Make sure that you have set the clock correctly. Set the sleep timer To set the sleep timer, in turn on mode, press SLEEP/TIMER repeatedly to select a set period of time (in minutes). Otherwise, disappears. Listen to an external device You can listen to an external device through this unit with an MP3 link cable (not supplied). 1 2 3 In standby mode, press and hold SLEEP/ TIMER for more than two seconds. Repeat step 2 to set minute, select a source (CD, FM, or USB), and adjust volume. Note 1 2 Press AUDIO IN repeatedly to select AUDIO IN source. Connect an MP3 link cable (not supplied) between: • AUDIO IN jack (3. 5 mm) on the unit, • and the headphone jack on an external device. For example, word documents (. doc) or MP3 files with extension . dlf are ignored and not played. • WMA, AAC, WAV, PCM audio files • DRM protected WMA files (. wav, . m4a, . m4p, . mp4, . aac) • WMA files in Lossless format Supported MP3 disc formats • • • • • ISO9660, Joliet Maximum title number: 128 (depending on file name length) Maximum album number: 99 Supported sampling frequencies: 32 kHz, 44. 1 kHz, 48 kHz Supported Bit-rates: 32~256 (kbps), variable bit rates 14 EN 8 Troubleshooting Warning •• Never remove the casing of this device. •• •• •• Insert the battery with its polarities (+/– signs) aligned as indicated. Aim the remote control directly at the sensor on the front of the unit. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this device, check the following points before requesting service. [. . . ] •• Reduce the distance between the remote control and the unit. No disc detected •• Insert a disc. •• Wait until the moisture condensation at the lens has cleared. Cannot display some files in USB device •• The number of folders or files in the USB device has exceeded a certain limit. USB device not supported •• The USB device is incompatible with the unit. [. . . ]