User manual CARLSBRO SLAMMER 2

[. . . ] For more information, talk to your local Carlsbro retailer of visit the website at WWW. CARLSBRO. COM for the full range of Carlsbro products. . Carlsbro Electronics Limited constantly seek ways to enhance our products, and improvements take place continually. Whilst every effort is made to produce up to date literature, Carlsbro Electronics Limited reserve the right to alter specifications without prior notice. STORAGE AND TRANSPORTATION Always store Your Slammer II on a flat surface away from any sources of moisture. [. . . ] Phono Inputs: These 2 connections are designed to take a stereo line level signal from a cd player, Laptop PC, MP3 player etc. The Red connection is the right channel input and the white connection is for the left channel. The wiring convention is as follows: Ring = Screen (Ground) Pin = Signal 4. Right XLR/Jack Inputs: This is identical to the left `combi' socket input, but for the right channel. Right Link Output: This is identical to the left link output, but for the right channel. Left Level: This controls the output level (volume) for the left Satellite speaker output. For maximum output turn this control clockwise until the `Limit' LED intermittently illuminates. The limit warning should illuminate only on the peaks of the signal, not continuously. Left Limit LED: This LED illuminates to indicate that the input signal to the amplifier is at its maximum allowable level and the signal is being limited to reduce distortion. 8. 120Hz Low Cut: This switch activates a 120Hz active high pass filter that removes all low bass signals from both left and right Satellite speaker outputs. 9. Right Level: This is identical to the left level control, but for the right channel. Right Limit LED: This is identical to the left Limit LED, but for the right channel. [. . . ] Should the mains fuse need replacing, it is located below the mains input. Always replace the fuse with type and rating printed on the rear panel of your Slammer II. [. . . ]