User manual CARLSBRO NLIGHTN PANELS

[. . . ] Thank you for buying Carlsbro" Andrew Bishop Chairman CARLSBRO ELECTRONICS LIMITED Evolution House, 6 Maisies Way, The Village, South Normanton, Derbyshire. DE55 2DS England WORLD CLASS PA & AMPLIFICATION SYSTEMS SINCE 1959 Experiment with these suggested settings when dialing in your tone. You can also tailor your sound with the type of pickups you use and where they are placed on the guitar. [. . . ] You can also tailor your sound with the type of pickups you use and where they are placed on the guitar. Humbuckers (dual coil pickups) generally have higher output than singlecoil pickups, and tend to overdrive more easily. Singlecoils usually have a brighter, `clearer' tone but less body to the sound. In addition, a pickup sounds tighter and more crisp closer to the bridge and has a warmer, more rounded sound closer to the neck. TECHNICAL SPECIFICATIONS: Voltage Requirement (Factory Preset) 230V 207V to 253V 50-60Hz 115V 104V to 126V 50-60Hz Power Consumption 25VA Power Output 12W RMS Output (8W) Height 280mm Width 270mm Depth 170mm Weight (Approx) 3. 5Kgs Carlsbro Electronics Limited constantly seek ways to enhance our products, and improvements take place continually. Whilst every effort is made to produce up to date literature, Carlsbro Electronics Limited reserve the right to alter specifications without prior notice. SUGGESTED SETTINGS: Classic Rock: INTRODUCTION: Metal: Thank you for buying a Kickstart 10. Correctly used it will provide years of reliable service and fulfill all you performance needs. Please read this user guide thoroughly in order to safeguard your equipment and to obtain maximum performance from it. Audio In: A 3. 5mm line level jack socket for connection of external audio devices (e. g. mp3 player, CD player), allowing you to play along to songs/recordings. Phones: 3. 5mm line level jack socket provides a mono signal for stereo headphone attachment. Note: that this disconnects the speaker, so headphones can be used for silent practice. When the amp is switched off, the LED will slowly go out. 2 1 1. Ensure that the AC power socket and plug are easily accessible during use NOTE: The unit is not isolated from the mains until the power cord is removed 2. Should the mains fuse need replacing, it is located below the mains input. Always replace the fuse with the same type and rating printed on the rear panel of your amp. [. . . ] Ensure that the AC power socket and plug are easily accessible during use NOTE: The unit is not isolated from the mains until the power cord is removed 2. Should the mains fuse need replacing, it is located below the mains input. Always replace the fuse with the same type and rating printed on the rear panel of your amp. [. . . ]