User manual CARLSBRO KICKSTART BASS 20

[. . . ] Thank you for buying Carlsbro" Andrew Bishop Chairman CARLSBRO ELECTRONICS LIMITED Evolution House, 6 Maisies Way, The Village, South Normanton, Derbyshire. DE55 2DS England WORLD CLASS PA & AMPLIFICATION SYSTEMS SINCE 1959 Experiment with these suggested settings when dialing in your tone. [. . . ] If it appears damaged in any way, return it to the retailer it was purchased from in its original packaging. Carlsbro Electronics Ltd cannot accept any responsibility for damage arising from the use of non-approved packaging Finger SYSTEM CONTENTS 1. Finger Kickstart Bass 20 Amp Mains Power Cable Manual Guarantee Card Nu Metal: Funk: Slap Jazz: Country: MAIN FEATURES: > > > > > > > > > High impedance universal input Variable input gain control Input limiting Peak power indicator Powerful active three band Eq Master volume control Universal Audio input Headphone output British designed Kevlar reinforced 8" PowertoneTM loudspeaker Note: gain control should be set at a suitable level for your instrument and the volume control sets how loud you want to play on all these suggested setting. TOP PANEL FEATURES REAR PANEL FEATURES 7 10 123456 89 1. Input: Using a good quality shielded signal cable, connect the output of your bass guitar to this socket. It is compatible with piezo transducers, active and passive pick-up systems. Gain: This control sets the gain at the input (the electrical signal strength). This control needs to be set higher for piezo and passive pick-ups, and lower for active pick-ups (where a battery is fitted inside the bass guitar). When setting the gain the peak light should not stay illuminated, however there is no problem if it flashes when you hit the strings hard. Bass: This is used to control the level of bass or low frequency sound. When the control is in the centre there no effect on the sound produced, turning the control to the left reduces the amount of bass, and turning the control to the right will increase it. [. . . ] Always replace the fuse with the same type and rating printed on the rear panel of your amp. If the replacement fuse blows immediately, then contact your local service agent. [. . . ]