User manual CARLSBRO HI-FIVE

[. . . ] Humbuckers (dual coil pickups) generally have higher output than singlecoil pickups, and tend to overdrive more easily. Singlecoils usually have a brighter, `clearer' tone but less body to the sound. In addition, a pickup sounds tighter and more crisp closer to the bridge and has a warmer, more rounded sound closer to the neck. [. . . ] Small shaft reverb is a small short reverb to imitate the feeling of playing in a room or small club. Deep Pit Reverb: Big, long reverb to imitate the feeling of playing in a large venue. Gated Shaft Reverb: Medium reverb with the addition of a noise gate to artificially cut the decay early 4. M1 Delay: Adds a number of repeats after the signal, allowing you to layer guitar notes over the top of each other. Shimmer Chorus: Chorus adds one or more copies of the sound a tiny fraction of a second later to give the feeling of two or more players in unison. Tight Flanger: Flanger adds the signal and a continually phase shifted signal together to produce sounds ranging from short swirls to those similar to a jet plane taking off. Bucket Flanger: A flange effect with a slow rate and lots of depth to create a 'jet plane' sound. Compresses the peaks in your playing and raises the whole signal level to produce a more stable, even signal. Carlsbro Electronics Limited constantly seek ways to enhance our products, and improvements take place continually. Please ensure the supplied AC power lead is connected to a mains supply socket fitted with a safety earth connection 3. Footswitch Socket: For the connection of a footswitch for remote channel switching and enabling/disabling of FX. Note: Footswitch will only work if the channel select button is pushed in. NOTE: ALWAYS DISCONNECT THE UNIT FROM THE MAINS SUPPLY BEFORE CHANGING THE FUSE. STORAGE When you are not using your amplifier, disconnect it from the mains supply and store it away from any source of moisture. 1. Connect your guitar here using a high quality, shielded instrument lead. Clean Gain: Adjusts the gain applied to the signal when in clean mode. Channel Switch: 'Clean' mode is enabled with the switch out. Channel Indicator LED: Will illuminate to show when lead channel is active 5. [. . . ] Lead Gain: Controls the amount of gain added to the lead channel Adding gain causes harmonic distortion of the signal, producing a fuller, crunchier sound for use in rock music. Boost Switch: When pushed in, this adds a gain boost to the lead channel. Bass: This is used to control the level of bass or low frequency sound. [. . . ]