User manual CARLSBRO COLT 85 SIDE 02

[. . . ] This is where you will find the description of the controls and the internal parts. 3. How to load your dishes (p. 3) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 4. 4) After loading the dishes, you need to select the right wash cycle and measure out the correct dose of detergent and rinse aid. Safety for you and your family (p. 9) Read this chapter carefully, as it will provide you with useful information on installation, use and maintenance safety. [. . . ] Indicator light “I” turns off and the 4 dashes appear to indicate that all the settings have been cancelled. Interrupt the wash cycle by pressing the Stand-by button, insert the dish you had forgotten and press the same button again. The end of the wash cycle is indicated by two short beeps and the word “END” flashes on the display. Warning: Turn the display off by pressing button “A”, unplug the appliance from the electricity socket to cut off the power supply; the power supply cable should consequently be easily accessible. • Empty the lower rack first. Make sure the wash cycle has ended before removing the dishes!The wash cycle stops and then restarts when the electricity comes back on or when you shut the door. Everything is under control! Mode and Select buttons and repeat the selection. If on the other hand you want to cancel the delay set and you wish to start the wash cycle immediately, press the Select button repeatedly until it is set to zero. The following indicator light will turn off: Do you want extra drying?Before you start the selected wash cycle, press button “M” (Mode) repeatedly until the extra drying symbol “G” is selected, and the corresponding rectangle lights up. Press button “S” (Select) and select On to enable the extra drying, or Off to disable it. There is an arrow on the neck of the container (see figure): if necessary, turn the arrow anticlockwise from the "-" setting to the "+" setting. Select the arrow position depending on the water hardness, referring to the table provided. You don't know how hard the water in your home is?Ask the company that supplies water in your area. Suggestions and advice for you. How to look after and protect the dishes you hold dear Savings are easy Using your electric household appliances wisely helps you make savings and is good for the environment. Maximum load. To optimise consumption levels, try to use the dishwasher with a full load only. If it takes quite some time to fill up your dishwasher, use the soak cycle to avoid the formation of bad odours and caked-on food. Select the most suitable wash cycle for the type of load you have placed in the dishwasher. The choice of wash cycle depends on the type of dishes to wash and on how dirty they are. To select the right wash cycle, please consult the wash cycle table on page 6. s Almost all silverware can be cleaned in a dishwasher. There are two exceptions: old silverware and silverware decorated with an oxidising agent. Hot water can loosen the handles on old silverware ad wear off the decorations on the other. Never let silverware come into contact with other metals: you will thus avoid stains and blackening Apart from making you save time and energy, your dishwasher disinfects your dishes, washing them at a high temperature. s Silver plates and serving dishes should be washed immediately after use, especially if they have contained salt, eggs, olives, mustard, vinegar, fruit juices and cooked vegetables. [. . . ] If the appliance malfunctions, turn off the water inlet tap and disconnect the plug from the wall socket. Then try consulting the section entitled "I you have a problem, read this". If you cannot resolve the problem, then call the service centre. If you have forgotten to turn on the water tap, your appliance will remind you with a long series of prolonged beeps and the wording H2O will flash up on the display. Turn the tap on and the wash cycle will start up after a few minutes. If the appliance is blocked and the code “AL05” is flashing, this means the filter is clogged by large particles of food residue. [. . . ]