User manual CARLSBRO COLT 40

[. . . ] This is where you will find the description of the controls and the internal parts. 3. How to load your dishes (p. 3) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 4. How to start your dishwasher (p. 4) After loading the dishes, you need to select the right wash cycle and measure out the correct dose of detergent and rinse aid. Reading these pages will help you through all the wash phases. 8. Safety for you and your family (p. 9) Read this chapter carefully, as it will provide you with useful information on installation, use and maintenance safety. 5) Using the right salt and in the right quantity will help you maintain your dishwasher in top condition, to wash better and to avoid possible damage caused by limescale. 9. [. . . ] Check whether there is any detergent residue on the edges of the dispenser. The rinse aid container is situated on the inside of the door: It should be filled up when the low rinse aid indicator light "T" flashes. To obtain the best results from each washing and drying cycle, powder detergent, rinse aid liquid and salt should be used. Loading the rinse aid. You can adapt the amount of rinse aid used by the dishwasher: regulate the adjuster F which you will find under lid C. You can choose from six different positions. You can choose from six different positions. It is normally set to 4. Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spotting occurs, turn the dosage adjuster to a higher setting. Economic and fast cycle Wash at 48°C to be used for slightly Hot rinse at 67°C dirty dishes. Preliminary wash cycle for dishes while the load is awaiting completion with the dishes from the next meal. Special cycle to be used for more delicate items which are sensitive to high temperatures. Short cold wash to prevent food from drying onto the dishes. 27 g (A) 27 ml (A) no yes 1:33’ 23 g (A) 23 ml (A) 3 g (B) 3 ml (B) no yes 2:25’ 20 g (A) 20 g (A) no yes 0:44’ Rapid & Dry no no no no 0:12' Soak Wash at 52°C Rinse at 45°C Hot rinse at 65°C Drying 20 g (A) 20 g (A) no yes 1:30’ Crystal Note: To make it easier to measure out the detergent, it is worth remembering that: 1 tablespoon = 15 grams of powder = approximately 15 ml of liquid 1 teaspoon = 5 grams of powder = approximately 5 ml of liquid $ ARISTON DISHWASHER - Instructions for installation and use Water hardness varies according to where you live. The dishwasher is provided with water supply and drain hoses, which can be directed towards the left or right to facilitate appropriate installation. This dishwasher model can be built under a single worktop (please read the relevant instruction sheet). Your dishwasher has arrived Hot water connection. Your dishwasher can be supplied with hot water from the mains supply (if you have a central heating system with radiators) at a temperature of no more than 60°C. In this case, the wash cycle time will be about 15 minutes shorter and the wash will be slightly less effective. The connection must be made to hot water supply following the same procedures as those indicated for the cold water connection. Fit the drain pipe into a drain line with a minimum diameter of 4 cm or place it over the sink. Use the special plastic elbow provided (see figure) to position it in the best possible way. The part of the pipe marked with the letter A should be between 40 and 100 cm above the ground. The pipe should not be immersed in water. A After having bought or moved your dishwasher to another home, a correct installation ensures that your dishwasher will operate smoothly and efficiently. Levelling. Once the appliance is positioned, adjust the feet by screwing them in or out depending on how high you want it and to level it so that it is horizontal. If the appliance is level, it will help ensure its correct operation. Anti-flooding protection Your dishwasher is provided with a special system which blocks the water supply in the event of leaks inside the appliance. Cold water connection. [. . . ] The entire filter assembly should be cleaned thoroughly once a month: cup C + semi-circular filter A + cylindrical filter B. Reassemble the filter parts (as shown in the figure) and reinsert the whole assembly into the dishwasher. Improper replacement of the filters may reduce the efficiency of the wash and even damage your dishwasher. 1 B 2 A Cleaning the sprayer arms. Food residue may become encrusted onto the sprayer arms and block the holes where water comes out. [. . . ]