User manual CARLSBRO COLT 120 SIDE 02

[. . . ] Humbuckers (dual coil pickups) generally have higher output than singlecoil pickups, and tend to overdrive more easily. Singlecoils usually have a brighter, `clearer' tone but less body to the sound. In addition, a pickup sounds tighter and more crisp closer to the bridge and has a warmer, more rounded sound closer to the neck. [. . . ] TECHNICAL SPECIFICATIONS: Voltage Requirement (Factory Preset) 230V 207-253V 50-60Hz ~ 115V 104-125V 50-60Hz ~ Power Consumption 49VA Power Output 30W rms (8W) Frequency Response 40Hz-4000Hz Height 407mm Width 404mm Depth 267mm Weight (Approx) 11Kgs Carlsbro Electronics Limited constantly seek ways to enhance our products, and improvements take place continually. Whilst every effort is made to produce up to date literature, Carlsbro Electronics Limited reserve the right to alter specifications without prior notice. SUGGESTED SETTINGS: Rock: PLAYING STYLE Plectrum INTRODUCTION Thank you for buying The Kickstart Bass 30. Correctly used it will provide years of reliable service and fulfill all you performance needs. Please read this user guide thoroughly in order to safeguard your equipment and to obtain maximum performance from it. The Kickstart Range of combos have been designed and voiced to be an ideal introduction to bass guitar amplification. They are designed to help you start playing and keep playing for years to come. The designs are deliberately simple for easy and intuitive operation, but still will produce a wide range of tones for different musical styles. They are ideally suited to home practice, producing versatile tones without extremes of volume. Bass: This is used to control the level of bass or low frequency sound. When the control is in the centre there no effect on the sound produced, turning the control to the left reduces the amount of bass, and turning the control to the right will increase it. Mid: This works the same as the Bass control but affects the mid-range frequencies. Mid Shift: This switch, when depressed, changes the control range of the Mid control (5. ) This switch when depressed moves the mid control down so that it effects the lower mid range of frequencies. The difference will only be noticed if the mid control is set to either 'cut' or boost'. Treble: This works the same as the Bass control but affects the treble or high frequencies. Peak Power Indicator: This red LED illuminates when the amplifier is starting to distort, if this light starts to illuminate turn the gain control to the left until the light stays off for a clean undistorted sound. 21 1. Ensure that the AC power socket and plug are easily accessible during use. [. . . ] Ensure that the AC power socket and plug are easily accessible during use. NOTE: The unit is not isolated from the mains until the power cord is removed 2. Should the mains fuse need replacing, it is located below the mains input. [. . . ]