User manual CAPRESSO F9

[. . . ] Impressa F9 Fully Automatic Coffee & Espresso Center with Claris Water Care System Operating Instructions and Warranty 63942R Customer Service 1-800-220-5701 IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. To protect against fire, electric shock and personal injury, do not immerse cord, plugs or appliance in water or other liquids. Close supervision is necessary when any appliance is used by or near children. Allow it to cool before putting on or taking off parts, and before cleaning the appliance. [. . . ] Tips for frothing (Cappuccino): Start in the steaming position (cylinder "up") for 10 to 20 seconds. If the frothed milk is not warm enough, continue in the steaming position. Steaming and frothing directly in your cappuccino cup: With practice, you can steam and froth directly in your cappuccino cup. Skim milk will produce the most froth and will let you taste more of the coffee. CLEANING THE DUAL FROTHER PLUS Always keep the Dual Frother Plus clean and free of milk deposits. Fast cleaning: · Immediately after finishing frothing, place a cup underneath the frother (Fig. Thorough cleaning of the Dual Frother parts: · Remove the Dual Frother (Fig. 16) from the Steam Nozzle (Fig. · Unscrew the black tip (Fig. 16a) from the Clip-On Connector (Fig. Make sure that the two side holes and the channel of the black tip (Fig. 17) · Place a cup underneath the Steam Nozzle (the Dual Frother is off) and press the Hot Water Button. Let hot water run for a few seconds through the Steam Nozzle. · Push the Hot Water Button again to stop. Tip: If the steam nozzle is blocked by hardened milk, use a needle and loosen up the milk deposit. · Assemble the Dual Frother and make sure that the tip is screwed onto the Connector (Fig 16a, c) finger tight. · Push the black Clip-on Connector (Fig. 16c) firmly into the steam nozzle (the connector should sit flush with the chrome sleeve so that the steam nozzle is no longer visible) Please note: If the parts are not put together tightly it will not be possible to create the frothy foam on top of the milk. CLARIS WATER CARTRIDGE The machine comes with one Claris water cartridge. The Claris water cartridge is specially made for use with the Impressa machines. · Removes (if present) up to 85% chlorine, up to 90% lead, up to 95% copper and up to 67% aluminum. 9) just before the brewing cycle starts, ensuring freshly filtered water every time you make coffee. When using the Claris water cartridge, you never need to decalcify your machine. · Is available through your retailer, the enclosed mail order form, or through www. capresso. com, or call 1-800-220-5701. 15. 16a. INSTALLING & ACTIVATING THE CLARIS WATER CARTRIDGE Important: Never install the cartridge before or during the first time preparation of the machine. · Open water container lid and pull up the holder for the Claris cartridge (Fig. 10). Make sure it fits snugly over the white mesh piece inside the water container. [. . . ] · Any service or alteration performed by an unauthorized person, company or association. · Damage caused by neglecting and omitting maintenance, cleaning and decalcifying cycles. · Damage caused by use of instant coffee or any other ingredients not allowed in this product. Other limitations and exclusions: Any implied warranties including fitness for use and mechantability are limited in duration to the period of the express warranty set forth above and no person is authorized to assume for JURACAPRESSO any other liability in connection with the sale of the machine. [. . . ]